Shop by category
Shop all componentsSensors & MCUs
The Beta model is accurate to about ±1 °C within 20–30 °C of the reference. For a wider range use the Steinhart–Hart equation with three calibration points.
1/T = 1/T0 + (1/B) × ln(R ÷ R0), T in kelvinR = R0 × e^(B × (1/T − 1/T0))Divider: R = Rfixed × code ÷ (max − code)A 10 kΩ, B = 3950 thermistor reading 5 kΩ: 1/T = 1/298.15 + ln(0.5) ÷ 3950 = 0.0031785, so T = 314.6 K = 41.5 °C. At 50 °C its resistance is 3.59 kΩ.
NTC thermistors lower their resistance as temperature rises, and by a lot: a 10 kΩ part falls to about 3.6 kΩ at 50 °C. Connecting one in a voltage divider with a fixed resistor lets an Arduino or ESP32 read temperature with a single analogue pin.
For the best accuracy, choose the fixed resistor close to the thermistor’s resistance at the temperature you care about, average several ADC samples, and check the Beta value on the datasheet, because common 3950 values are approximations. 3D printer hot ends use 100 kΩ thermistors with the same equation.
A constant from the datasheet, often 3950 K for 10 kΩ NTCs. It sets how fast resistance falls as temperature rises.
Wire it in a divider with a 10 kΩ resistor, read the ADC, compute R, then use the Beta formula to get temperature.
With the Beta formula, usually within about 1 °C over 0 to 50 °C. Calibration improves it.
1/T = 1/T0 + (1/B) × ln(R ÷ R0), T in kelvin; R = R0 × e^(B × (1/T − 1/T0)); Divider: R = Rfixed × code ÷ (max − code).
A 10 kΩ, B = 3950 thermistor reading 5 kΩ: 1/T = 1/298.15 + ln(0.5) ÷ 3950 = 0.0031785, so T = 314.6 K = 41.5 °C. At 50 °C its resistance is 3.59 kΩ.
Geekobot builds that use it include Warm box for dough and yoghurt with a PTC heater and a safety cut-out. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators