Component guide · Advanced · 4 min read
Drone mmWave Radar

NanoRadar NRA24, NRA15, UAM231 Altimeters, Microbrain Terrain and Obstacle Radars, Jiyi Radars
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
Radar altimeters measure height above ground for terrain following, landing and crop spraying, and work over crops, water and dust where LiDAR and sonar struggle. The NanoRadar NRA24 reads 0.1 to 50 m and the UAM231 up to 1000 m. Microbrain and Jiyi obstacle radars watch ahead or behind out to 25 to 120 m. They connect over UART or CAN.
Key specs at a glance
- Frequency
- 24 GHz or 77 to 81 GHz
- Altimeter range
- 0.1 to 50 m (NRA24), up to 200 m (UAV-H201), 1000 m (UAM231)
- Obstacle range
- 1.5 to 27 m or up to 120 m
- Interface
- UART, CAN, RS232, RS485 (model dependent)
- Supply
- About 5 to 32 V (check model)
- Protection
- Often IP67
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1NanoRadar NRA24 24GHz Altimeter Radar Module – FMCW, UART/USB Interface, 0.1-50m Range₹28,049
Option 2NanoRadar NRA15 24GHz Altimeter Radar Module – UART Interface₹26,679
Option 3NanoRadar UAM231 24GHz Altimeter Radar – 1000m Range, IP67, UART/CAN/RS232/422/485₹1,55,499
Option 4Microbrain Intelligent UAV-H31-1 77–81GHz Height Measuring Radar (0.1–27 m) – UART Interface, IP67₹19,809
Option 5Microbrain Intelligent UAV-H201-1 77–81GHz Terrain Sensor (0.9–200 m) – UART Interface₹18,849
Option 6Microbrain Intelligent UAV-H30-1 CAN Terrain Following Radar Sensor (0.2–27 m)₹17,949
What the Drone radar altimeters and obstacle avoidance radars is
Drone mmWave radars measure height above ground and detect obstacles, working in dust, fog and darkness where cameras and lasers struggle.
Agricultural drones fly a few metres above uneven crops, so they need a height sensor that sees through spray mist. That is where radar shines.
ArduPilot supports several of these radars as rangefinders (for example NanoRadar NRA24 over UART or CAN). Check the ArduPilot rangefinder list for your exact model.
Drone radar altimeters and obstacle avoidance radars pinout
The pins on the Drone radar altimeters and obstacle avoidance radars and what each one does.
| Pin | Function |
|---|---|
| V+ / GND | Supply |
| TX / RX | UART |
| CAN H / CAN L | CAN bus |
| A / B | RS485 (some models) |
- V+ / GND
- Supply
- TX / RX
- UART
- CAN H / CAN L
- CAN bus
- A / B
- RS485 (some models)
Wiring the Drone radar altimeters and obstacle avoidance radars
On a drone, connect UART or CAN straight to the flight controller instead.
| Drone radar altimeters and obstacle avoidance radars pin | Arduino Uno | ESP32 |
|---|---|---|
| Power + | 12 V supply + | 12 V supply + |
| Power - | Supply - and board GND | Supply - and board GND |
| CAN H | MCP2515 CANH | MCP2515 CANH |
| CAN L | MCP2515 CANL | MCP2515 CANL |
| MCP2515 CS / SCK / SI / SO / INT | D10 / D13 / D11 / D12 / D2 | GPIO 5 / 18 / 23 / 19 / 4 |
- Power +
- Arduino Uno:
- 12 V supply +
- ESP32:
- 12 V supply +
- Power -
- Arduino Uno:
- Supply - and board GND
- ESP32:
- Supply - and board GND
- CAN H
- Arduino Uno:
- MCP2515 CANH
- ESP32:
- MCP2515 CANH
- CAN L
- Arduino Uno:
- MCP2515 CANL
- ESP32:
- MCP2515 CANL
- MCP2515 CS / SCK / SI / SO / INT
- Arduino Uno:
- D10 / D13 / D11 / D12 / D2
- ESP32:
- GPIO 5 / 18 / 23 / 19 / 4
Example code
Parameter values depend on the radar and firmware version; follow the ArduPilot page for your model.
RNGFND1_TYPE = 11 or 39 (see ArduPilot docs for your radar's driver)
RNGFND1_MIN_CM = 20
RNGFND1_MAX_CM = 5000
RNGFND1_ORIENT = 25 (downward)
CAN_P1_DRIVER = 1
CAN_D1_PROTOCOL = per the radar driver
Reboot, then check rangefinder distance in the status page.Setup and tuning
mount the altimeter facing down with a clear view, away from props and legs.
connect UART or CAN to the autopilot and set the rangefinder type in parameters.
set minimum and maximum distance in the autopilot to match the radar.
feed from a clean 5 V or 12 V rail as the radar specifies.
check readings over grass, water and crops before relying on them.
What you need
Shop this list15 of 15 found in our store · ₹3,94,730
NanoRadar NRA24 24GHz Altimeter Radar Module – FMCW, UART/USB Interface, 0.1-50m Range: the part this guide coversNanoRadar NRA24 24GHz Altimeter Radar Module – FMCW, UART/USB Interface, 0.1-50m Range₹28,049
NanoRadar NRA15 24GHz Altimeter Radar Module – UART Interface: another version this guide coversNanoRadar NRA15 24GHz Altimeter Radar Module – UART Interface₹26,679
NanoRadar UAM231 24GHz Altimeter Radar – 1000m Range, IP67, UART/CAN/RS232/422/485: another version this guide coversNanoRadar UAM231 24GHz Altimeter Radar – 1000m Range, IP67, UART/CAN/RS232/422/485₹1,55,499
Microbrain Intelligent UAV-H31-1 77–81GHz Height Measuring Radar (0.1–27 m) – UART Interface, IP67: another version this guide coversMicrobrain Intelligent UAV-H31-1 77–81GHz Height Measuring Radar (0.1–27 m) – UART Interface, IP67₹19,809
Microbrain Intelligent UAV-H201-1 77–81GHz Terrain Sensor (0.9–200 m) – UART Interface: another version this guide coversMicrobrain Intelligent UAV-H201-1 77–81GHz Terrain Sensor (0.9–200 m) – UART Interface₹18,849
Microbrain Intelligent UAV-H30-1 CAN Terrain Following Radar Sensor (0.2–27 m): another version this guide coversMicrobrain Intelligent UAV-H30-1 CAN Terrain Following Radar Sensor (0.2–27 m)₹17,949
Microbrain Intelligent Intelligent UAV-R121-1 77–81GHz Obstacle Avoidance Radar (1.5–120 m) – UART IP67: another version this guide coversMicrobrain Intelligent UAV-R121-1 77–81GHz Obstacle Avoidance Radar (1.5–120 m) – UART IP67₹17,409
Microbrain Intelligent Intelligent UAV-R22-1 77–81GHz Obstacle Avoidance Radar (1.5–27 m) – UART Interface: another version this guide coversMicrobrain Intelligent UAV-R22-1 77–81GHz Obstacle Avoidance Radar (1.5–27 m) – UART Interface₹17,579
UAV-R21-1 CAN Obstacle Avoidance Radar (1.5–27 m) – IP67 Waterproof: another version this guide coversUAV-R21-1 CAN Obstacle Avoidance Radar (1.5–27 m) – IP67 Waterproof₹17,949
Jiyi Front Obstacle Avoidance Radar Module – 24GHz FMCW, 1-25m Range: another version this guide coversJiyi Front Obstacle Avoidance Radar₹21,403
Jiyi Back Obstacle Avoidance Radar Module – 24GHz FMCW, 1-25m Range, IP67: another version this guide coversJiyi Back Obstacle Avoidance Radar₹21,272
Holybro Pixhawk 6C flight controller: to use it on a drone or roverHolybro Pixhawk 6C Mini Flight Controller₹21,938Closest match, check the specs
MCP2515 CAN bus module (TJA1050): to read CAN radars from an Arduino or ESP32MCP2515 CAN Bus Module TJA1050 Transceiver SPI Arduino₹108Closest match, check the specs
NanoRadar USB to CAN adapter: the maker's adapter for its PC toolsNanoRadar USB to CAN Adapter – USB 2.0 to CAN BUS Converter₹7,909Closest match, check the specs
Benewake TF-Luna micro LiDAR: a laser alternative for short rangeBenewake TF-LUNA Micro LiDAR Distance Sensor (Range: 0.2m~8m) – UART/I2C Interface₹2,329Closest match, check the specs
Alternatives and when to choose them
- Single-point LiDAR: cheaper, struggles in mist.
- Pixhawk and ArduPilot: flight controller set-up.
- Automotive radar: vehicle collision radars.
Common mistakes to avoid
- Mounting the radar where landing legs block it.
- Setting range limits that do not match the radar.
- Powering it from a noisy BEC.
- Trusting it over new terrain without testing.
Frequently asked questions
Why use radar instead of a LiDAR altimeter?
Radar works in dust, rain and fog and over crops where LiDAR readings jump.
Does ArduPilot support these radars?
Many NanoRadar models are supported as rangefinders or proximity sensors.
Can it measure height over water?
Yes, radar reflects from water, though rough water adds noise.
What is the obstacle radar used for?
It detects objects ahead so the drone can slow or stop.
How high can the altimeter measure?
From about 50 m to hundreds of metres, depending on the model.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.



