Component guide · Beginner · 3 min read
Force Sensitive Resistors (FSR)
Wiring and Limits
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
A force sensitive resistor is a thin, flexible pad whose resistance falls as you press it, from over 1 MΩ untouched to a few kΩ or less under firm pressure. Wire it as a voltage divider with a 10 kΩ resistor and read it on an analog pin. FSRs suit detecting a press, a squeeze or someone sitting down, but they are not accurate enough to weigh things; use a load cell for that.
Key specs at a glance
- Resistance
- Over 1 MΩ with no force, falling to about 1 to 10 kΩ or below
- Force range
- Roughly 0.2 N to 20 N for small round FSRs
- Repeatability
- About ±10% or worse; drifts with time
- Response
- Fast, under a few ms
- Thickness
- Under 0.5 mm
- Wiring
- Voltage divider with a 3.3 to 100 kΩ resistor
Wiring
Connect one FSR lead to 5 V (or 3.3 V), the other to an analog pin, and a 10 kΩ resistor from that pin to GND. With no force the pin reads near 0; pressing raises the reading. A larger resistor gives more sensitivity to light touches; a smaller one spreads the range for heavy presses. See the voltage divider calculator and ADC basics.
Do not solder directly to the silver tabs: the plastic melts. Use a female header, a clincher connector or a screw terminal.
What an FSR can and cannot do
The response is non-linear and varies by about 10% between parts and over time, so treat the reading as 'none, light, medium, firm' rather than newtons. Press over the whole active area with a small rubber puck for more consistent readings. For weighing, use a load cell with an HX711.
Project ideas
Pressure-sensitive drum pads and MIDI controllers, seat occupancy detection, robot gripper feedback (stop closing when the FSR reads firm), interactive art, and squeeze toys.
Try it: Voltage divider calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Soldering to the tabs and melting the sensor.
- Using it as a weighing scale.
- Pressing only part of the active area.
- Bending the pad sharply at the tail.
- Leaving out the divider resistor.
Frequently asked questions
Can an FSR measure weight?
Only roughly. It is not linear or repeatable enough; use a load cell for weight.
What resistor should I use with an FSR?
10 kΩ is a good start. Use 47 to 100 kΩ for light touches and 3.3 kΩ for heavy presses.
Does an FSR work with ESP32?
Yes. Power the divider from 3.3 V and read an ADC1 pin.
How do I connect an FSR without soldering?
Push the tail into a female header or use a crimp clincher connector.
Why does my FSR reading drift?
FSRs creep under constant load and vary with temperature. Use them for detection rather than measurement.
Parts for this guide
- ₹248View
Calculators
Terms in this guide
Projects that use it
Put this into practice: 2 step-by-step builds in our project library use parts from this guide.
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.

