Component guide · Advanced · 4 min read
Integrated Heavy-Lift Propulsion

Hobbywing XRotor X6 Plus, X8, X11 Plus, X11 Max, X13 and H11M with Folding Props, K5 Propulsion Epitome XT 100KV and XT Ultra 75KV CW and CCW
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
An integrated propulsion system combines the motor, a FOC ESC and a matched folding propeller in one arm-mounted unit. Hobbywing XRotor X6, X8, X9, X11 and X13 are widely used on agriculture spray drones; the number rises with size and thrust. K5 Epitome XT units do the same for heavy-lift multirotors. You only connect battery power and one signal wire per arm, which makes building and service simpler.
Key specs at a glance
- Thrust
- About 10kg per arm (X6) to over 50kg (X13, H11M)
- Voltage
- 12S to 18S typical, 14S on many agriculture drones
- ESC
- Built-in FOC, PWM input, some with CAN telemetry
- Props
- 24 to 56 inch folding, CW and CCW
- Protection
- IP67 on Hobbywing agriculture sets
- Mount
- Tube clamp for 30, 35 or 40mm arms
This part can carry many amps. Use wire thick enough for the current, put a fuse close to the battery, check that connectors are rated for the load and give drivers and motors room to cool. A short at these currents melts wires in seconds.
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1Hobbywing H11M Motor, 150A FOC ESC & 48×17.5 Propeller Set₹1,50,879
Option 2Hobbywing X11 Plus Motor with 4314 Propeller CW₹31,559
Option 3Hobbywing XRotor X6 Plus 150KV Motor & 2480 Prop CW₹11,859
Option 4Hobbywing XRotor X6 Plus Motor & 2480 Folding Propeller CCW₹11,849
Option 5Hobbywing XRotor X8 100KV Motor & 3011 Folding Propeller CW₹15,429
Option 6Hobbywing Xrotor X11 Max Motor with 482609 Propeller CW₹37,769
What the Hobbywing XRotor and K5 Epitome integrated propulsion systems is
Hobbywing X-Rotor and K5-series propulsion systems are integrated motor, ESC and propeller sets for agricultural, heavy-lift and industrial drones.
Choose by thrust: total take-off weight times about 1.8 divided by the number of arms gives the maximum thrust each unit should reach. X6 suits 10 to 16 litre sprayers on four or six arms, X8 and X9 suit 20 to 30 litre machines, and X11 and X13 suit heavy payloads.
Order matching CW and CCW units for your frame layout. Run PWM from the flight controller and, where supported, CAN for RPM and temperature telemetry. Rinse spray residue off after use and keep connectors greased.
Hobbywing XRotor and K5 Epitome integrated propulsion systems pinout
The pins on the Hobbywing XRotor and K5 Epitome integrated propulsion systems and what each one does.
| Pin | Function |
|---|---|
| Phase wires | 3 motor wires to ESC A, B, C |
| Mount | Bolt pattern on the base, per data sheet |
| Shaft / prop mount | Prop adapter or integrated clamp |
| Rotation | CW or CCW marked on prop-nut motors |
| Signal (integrated) | PWM or CAN on motor-ESC sets |
- Phase wires
- 3 motor wires to ESC A, B, C
- Mount
- Bolt pattern on the base, per data sheet
- Shaft / prop mount
- Prop adapter or integrated clamp
- Rotation
- CW or CCW marked on prop-nut motors
- Signal (integrated)
- PWM or CAN on motor-ESC sets
Wiring the Hobbywing XRotor and K5 Epitome integrated propulsion systems
Use thick enough power wire and anti-spark connectors for 12S and above.
| Hobbywing XRotor and K5 Epitome integrated propulsion systems pin | Connection | Note |
|---|---|---|
| Motor phases | ESC outputs | Swap any two to reverse |
| ESC power | Battery via PDB | Correct cell count |
| ESC signal | Flight controller output | PWM or DShot / CAN |
- Motor phases
- Connection:
- ESC outputs
- Note:
- Swap any two to reverse
- ESC power
- Connection:
- Battery via PDB
- Note:
- Correct cell count
- ESC signal
- Connection:
- Flight controller output
- Note:
- PWM or DShot / CAN
Example code
Hobbywing's DataLink box lets you update ESC firmware and read logs.
1. Confirm cell count, KV and prop size against the maker's thrust table.
2. Torque the motor bolts with thread locker; check prop direction (CW/CCW).
3. Calibrate ESCs or set DShot/CAN in the flight controller.
4. Spin each motor without props: check direction in the motor test page.
5. Fit props, tie the drone down and run a short throttle test while watching current.
6. First hover low, then check motor temperature after landing.Setup and tuning
choose the arm size, battery voltage and prop size from Hobbywing's tables for your drone weight.
connect the PWM or CAN signal from the autopilot and calibrate throttle range if needed.
set CW or CCW on each arm per the frame layout and fit matching props.
use thick battery wires and anti-spark connectors on 12S to 14S packs.
these sets are rated for spray, but keep connectors sealed.
What you need
Shop this list13 of 13 found in our store · ₹4,70,437
Hobbywing H11M Motor, 150A FOC ESC & 48×17.5 Propeller Set: the part this guide coversHobbywing H11M Motor, 150A FOC ESC & 48×17.5 Propeller Set₹1,50,879
Hobbywing X11 Plus Motor with 4314 Propeller CW: another version this guide coversHobbywing X11 Plus Motor with 4314 Propeller CW₹31,559
Hobbywing XRotor X6 Plus 150KV Motor & 2480 Prop CW: another version this guide coversHobbywing XRotor X6 Plus 150KV Motor & 2480 Prop CW₹11,859
Hobbywing XRotor X6 Plus Motor & 2480 Folding Propeller CCW: another version this guide coversHobbywing XRotor X6 Plus Motor & 2480 Folding Propeller CCW₹11,849
Hobbywing XRotor X8 100KV Motor & 3011 Folding Propeller CW: another version this guide coversHobbywing XRotor X8 100KV Motor & 3011 Folding Propeller CW₹15,429
Hobbywing Xrotor X11 Max Motor with 482609 Propeller CW: another version this guide coversHobbywing Xrotor X11 Max Motor with 482609 Propeller CW₹37,769
Hobbywing Xrotor X13 Motor with 5620 Propeller CW: another version this guide coversHobbywing Xrotor X13 Motor with 5620 Propeller CW₹52,499
K5 Propulsion Epitome XT Propulsion System 100KV – CCW: another version this guide coversK5 Propulsion Epitome XT Propulsion System 100KV – CCW₹35,928
K5 Propulsion Epitome XT Propulsion System 100KV – CW: another version this guide coversK5 Propulsion Epitome XT Propulsion System 100KV – CW₹36,465
K5 Propulsion Epitome XT Ultra Propulsion System 75KV – CCW: another version this guide coversK5 Propulsion Epitome XT Ultra Propulsion System 75KV – CCW₹42,664
K5 Propulsion Epitome XT Ultra Propulsion System 75KV – CW: another version this guide coversK5 Propulsion Epitome XT Ultra Propulsion System 75KV – CW₹43,311
Digital multimeter: to check supply and signal voltagesDigital Multimeter₹177
Dupont jumper wires: for the connectionsDupont Jumper Wires (40 pcs)₹49Closest match, check the specs
Alternatives and when to choose them
- Large UAV motors 50xx and up: separate motors.
- T-Motor UAV motors: T-Motor range.
- BLDC motors and ESCs: basics.
Common mistakes to avoid
- Picking a set too small for the take-off weight.
- Wrong prop direction on an arm.
- Skipping throttle calibration on PWM.
- Using thin battery wires.
Frequently asked questions
How do I pick the right X-Rotor set?
Use Hobbywing's thrust table for your take-off weight, battery voltage and prop size.
Do X-Rotor sets need throttle calibration?
With PWM, yes; follow the manual.
Can I use them with Pixhawk or ArduPilot?
Yes, using PWM or DroneCAN outputs.
Why does one arm run hotter?
Check prop balance, direction and the motor mount.
Are these propulsion sets waterproof?
They are spray resistant for crop spraying, not submersible.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.
