Component guide · Beginner · 5 min read
LM75, LM75A, TMP75, TMP175, PCT2075, STLM75, ADT75

and DS75 I2C Temperature Sensors
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
The LM75 family are tiny I2C temperature sensors with a built-in thermostat output (OS). Many makers build compatible versions: NXP LM75A and PCT2075, TI TMP75 and TMP175, ST STLM75, ADI ADT75 and DS75. All read the temperature from register 0 at addresses starting 0x48, with 9 to 12-bit resolution and about plus or minus 1 to 2 degrees C accuracy.
Key specs at a glance
- Supply
- About 2.7 to 5.5 V (1.4 V parts exist)
- Interface
- I2C / SMBus, 0x48 to 0x4F (TMP175 and PCT2075 have more)
- Resolution
- 9 to 12 bits (0.5 to 0.0625 degrees C)
- Accuracy
- Plus or minus 1 to 2 degrees C typical
- Range
- -55 to 125 degrees C
- OS output
- Open drain, comparator or interrupt mode
This part is often wired to 230 V mains. Do all wiring with the plug pulled out, keep mains wires inside a closed box with strain relief, add a fuse, and never touch the board while it is plugged in. If you are new to mains wiring, have an electrician check it before you switch on.
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1LM75 Digital Temperature Sensor Module I2C 3.3V-5V₹209
Option 2WCMCU-75 LM75A High Speed I2C Temperature Sensor Module₹93
Option 3MSKSEMI LM75BDP-MS -55℃ to +125℃ I2C Digital Temperature Sensor – MSOP-8 Package₹67
Option 4NXP Semiconductors LM75AD,118 SOIC-8 Digital Temperature Sensor IC₹69
Option 5NXP Semiconductors LM75BD,118 SOIC-8 Digital Temperature Sensor IC₹48
Option 6NXP Semiconductors LM75BTP,147 HWSON-8-EP(2×3) Temperature Sensor IC₹38
What the LM75, TMP75, TMP175 and PCT2075 sensors is
The LM75 and TMP75 are simple I2C digital temperature sensors with about ±2 °C (LM75) or ±1 °C (TMP75) accuracy and an over-temperature alarm output.
The OS pin can switch a fan or flag a fault without any software: write the limits to the THYST and TOS registers once and the chip does the rest.
Packages are SOIC-8, MSOP-8, TSSOP or tiny DFN. The modules (WCMCU-75, LM75 module) add pull-ups and address jumpers so you can use eight on one bus.
LM75, TMP75, TMP175 and PCT2075 sensors pinout
The pins on the LM75, TMP75, TMP175 and PCT2075 sensors and what each one does.
| Pin | Function |
|---|---|
| SDA, SCL | I2C |
| OS / ALERT | Thermostat output (open drain) |
| A0, A1, A2 | Address select |
| VCC, GND | Power |
- SDA, SCL
- I2C
- OS / ALERT
- Thermostat output (open drain)
- A0, A1, A2
- Address select
- VCC, GND
- Power
Wiring the LM75, TMP75, TMP175 and PCT2075 sensors
For bare chips add 4.7 k pull-ups on SDA, SCL and OS and a 100 nF capacitor next to VCC.
| LM75, TMP75, TMP175 and PCT2075 sensors pin | Arduino Uno | ESP32 |
|---|---|---|
| VCC | 5 V or 3.3 V | 3.3 V |
| GND | GND | GND |
| SDA / SCL | A4 / A5 | GPIO 21 / 22 |
| OS (optional) | D2 with pull-up | GPIO 27 with pull-up |
- VCC
- Arduino Uno:
- 5 V or 3.3 V
- ESP32:
- 3.3 V
- GND
- Arduino Uno:
- GND
- ESP32:
- GND
- SDA / SCL
- Arduino Uno:
- A4 / A5
- ESP32:
- GPIO 21 / 22
- OS (optional)
- Arduino Uno:
- D2 with pull-up
- ESP32:
- GPIO 27 with pull-up
Example code
A minimal sketch to check the part works.
#include <Wire.h>
const uint8_t ADDR = 0x48; // A0 to A2 low; up to 0x4F
void setup() { Serial.begin(115200); Wire.begin(); }
void loop() {
Wire.beginTransmission(ADDR); Wire.write(0x00); Wire.endTransmission();
Wire.requestFrom(ADDR, (uint8_t)2);
int16_t raw = (Wire.read() << 8) | Wire.read();
float t = (raw >> 5) * 0.125; // 11-bit LM75A / PCT2075; use >> 7 * 0.5 for 9-bit LM75
Serial.print(t, 2); Serial.println(" C");
delay(1000);
}Setup and tuning
VCC (2.7 to 5.5 V), GND, SDA and SCL with pull-ups.
pins A0 to A2 set the address from 0x48 to 0x4F, so up to 8 sensors share one bus.
read the temperature register; the Wire library or a small LM75 library is enough.
set the OS (over-temperature) threshold to switch a fan or warn without code.
keep the chip away from heat sources on the board, unless you are measuring them.
What you need
Shop this list20 of 20 found in our store · ₹1,406
LM75 Digital Temperature Sensor Module I2C 3.3V-5V: the part this guide coversLM75 Digital Temperature Sensor Module I2C 3.3V-5V₹209
WCMCU-75 LM75A High Speed I2C Temperature Sensor Module: another version this guide coversWCMCU-75 LM75A High Speed I2C Temperature Sensor Module₹93
MSKSEMI LM75BDP-MS -55℃ to +125℃ I2C Digital Temperature Sensor – MSOP-8 Package: another version this guide coversMSKSEMI LM75BDP-MS -55℃ to +125℃ I2C Digital Temperature Sensor – MSOP-8 Package₹67
NXP Semiconductors LM75AD,118 SOIC-8 Digital Temperature Sensor IC: another version this guide coversNXP Semiconductors LM75AD,118 SOIC-8 Digital Temperature Sensor IC₹69
NXP Semiconductors LM75BD,118 SOIC-8 Digital Temperature Sensor IC: another version this guide coversNXP Semiconductors LM75BD,118 SOIC-8 Digital Temperature Sensor IC₹48
NXP Semiconductors LM75BTP,147 HWSON-8-EP(2×3) Temperature Sensor IC: another version this guide coversNXP Semiconductors LM75BTP,147 HWSON-8-EP(2×3) Temperature Sensor IC₹38
NXP Semiconductors PCT2075D,118 SOIC-8 Digital Temperature Sensor IC: another version this guide coversNXP Semiconductors PCT2075D,118 SOIC-8 Digital Temperature Sensor IC₹28
STMicroelectronics STLM75M2F Digital Temperature Sensor IC – SOIC-8 Package: another version this guide coversSTMicroelectronics STLM75M2F Digital Temperature Sensor IC – SOIC-8 Package₹78
STMicroelectronics STTS75M2F SO-8 Digital Temperature Sensor IC: another version this guide coversSTMicroelectronics STTS75M2F SO-8 Digital Temperature Sensor IC₹67
NXP Semiconductors TMP175AIDGKR Digital Temperature Sensor IC – MSOP-8 Package: another version this guide coversNXP Semiconductors TMP175AIDGKR Digital Temperature Sensor IC – MSOP-8 Package₹26
UMW TMP175AIDGKR Digital Temperature Sensor IC – MSOP-8 Package: another version this guide coversUMW TMP175AIDGKR Digital Temperature Sensor IC – MSOP-8 Package₹35
UMW TMP175AIDR SOP-8 Digital Temperature Sensor IC: another version this guide coversUMW TMP175AIDR SOP-8 Digital Temperature Sensor IC₹56
UMW TMP75AIDGKR Digital Temperature Sensor IC – MSOP-8 Package: another version this guide coversUMW TMP75AIDGKR Digital Temperature Sensor IC – MSOP-8 Package₹29
UMW TMP75AIDR SOP-8 Digital Temperature Sensor IC: another version this guide coversUMW TMP75AIDR SOP-8 Digital Temperature Sensor IC₹35
Analog Devices ADT75ARZ Digital Temperature Sensor IC, ±2°C Accuracy, -55°C to 125°C, NSOIC-8: another version this guide coversAnalog Devices ADT75ARZ Digital Temperature Sensor IC, ±2°C Accuracy, -55°C to 125°C, NSOIC-8₹87
Analog Devices ADT75BRMZ Digital Temperature Sensor IC, ±1°C Accuracy, -55°C to 125°C, MSOP-8: another version this guide coversAnalog Devices ADT75BRMZ Digital Temperature Sensor IC, ±1°C Accuracy, -55°C to 125°C, MSOP-8₹85
Analog Devices DS75LVU+ Digital Temperature Sensor IC, Low Voltage, ±2°C, µSOP-8: another version this guide coversAnalog Devices DS75LVU+ Digital Temperature Sensor IC, Low Voltage, ±2°C, µSOP-8₹143
Analog Devices DS1775R Digital Temperature Sensor IC, Digital Thermometer/Thermostat, ±2°C, -55°C to 125°C, SOT-23-5: another version this guide coversAnalog Devices DS1775R Digital Temperature Sensor IC, Digital Thermometer/Thermostat, ±2°C, -55°C to 125°C, SOT-23-5₹115
NOVOSENSE NST175H-QSPR SOP-8 Temperature Sensor IC: another version this guide coversNOVOSENSE NST175H-QSPR SOP-8 Temperature Sensor IC₹68
GXCAS GX75C SOP8 Temperature Sensor IC – 1.4V to 5.5V, -55°C to 125°C: another version this guide coversGXCAS GX75C SOP8 Temperature Sensor IC – 1.4V to 5.5V, -55°C to 125°C₹30
Alternatives and when to choose them
- TMP102 and TMP119: smaller and more accurate.
- Digital temperature sensor ICs: overview of IC sensors.
- DS18B20: 1-Wire probe alternative.
Common mistakes to avoid
- Leaving the address pins floating.
- Using it where ±0.5 °C accuracy is required.
- Mounting it next to a regulator.
- Forgetting the I2C pull-ups.
Frequently asked questions
How accurate is the LM75?
About ±2 °C; the TMP75 improves this to about ±1 °C.
How many LM75 sensors can share one bus?
Up to eight, using the A0 to A2 address pins.
What is the OS pin for?
It switches when temperature passes a set limit, like a built-in thermostat.
Does the LM75 work at 3.3 V and 5 V?
Yes, it runs from 2.7 to 5.5 V; match pull-ups to the board voltage.
Why does it read a few degrees high?
Heat from nearby parts or the board warms it; move it or add copper cut-outs.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.




