Raspberry Pi Pico weather display (MicroPython)
Your first MicroPython project: temperature and humidity on an OLED.
Shop by category
Shop all componentsBeyond Arduino, every chip family has its own SDK, IDE and debugger. This project runs the vendor's blink and hello-world examples on an NXP FRDM board, a RISC-V VSDSquadron Mini and a small Cortex-M0 board through a DAPLink probe, so you learn how projects, clocks and debug probes differ.
All three boards use 3.3 V logic.
Tick anything you already have and the total updates.
NXP Arm Cortex-M33 board with on-board debugger
CMSIS-DAP / ST-LINK probe with a UART
Follow the colours: red is power, dark grey is ground, blue is a signal.
Install the probe driver or update its firmware, and try another USB cable.
Check the boot pins and that the image was written to flash, not RAM.
Match the baud rate in the example.
The one used in products you want to build; STM32 and NXP are common in industry, RISC-V is growing fast.
The core is simpler; tools are less polished on some boards.
Some have community cores, but vendor SDKs expose every feature.
4 parts: NXP Semiconductors FRDM-MCXA153 Development Board, VSDSquadron Mini RISC-V 32-bit MCU Dev Board, HK32F030MF4P6 Cortex-M0 Core Development Board and WeAct Studio Mini Debugger DAPLink STLink V2.1 SWD/UART. On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 1 day. The build on this page has 5 steps.
About ₹3,998 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
All three boards use 3.3 V logic.
Ideas that reuse this build: STM32 first steps and FPGA LED counter. They are listed under Take it further on this page.
Your first MicroPython project: temperature and humidity on an OLED.
A web page with ON and OFF buttons that switches a relay over Wi-Fi.
A warm ring light that fades up at dusk and down at dawn.
Turn a Pi and a touchscreen into a home command centre with a clock and to-do list.
Learning project. Check every circuit and the datasheet of each part before you power it up.