Concept explainer · Beginner · 3 min read
ESD Safety
Protect Chips from Static Electricity
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
Electrostatic discharge (ESD) is the spark from static charge on your body, often thousands of volts, which you may not even feel. It can kill or weaken MOSFETs, CMOS chips, sensors and Wi-Fi modules. Protect parts by working on a grounded ESD mat, wearing a wrist strap connected through its built-in resistor, storing boards in shielding bags and touching ground before handling them. Dry air makes static much worse.
Key specs at a glance
- Wrist strap
- Contains about 1 MΩ series resistor for safety
- ESD mat
- Dissipative surface connected to ground
- Bags
- Shielding (metallised) bags protect; pink bags only resist charge build-up
- Sensitive parts
- MOSFETs, CMOS ICs, RF modules, image sensors, LEDs
- Humidity
- Below about 30 % relative humidity raises static risk
- Grounding
- Earth point of a properly wired socket or ground terminal
Why static matters
Walking across a carpet can charge your body to several thousand volts. You feel a spark only above about 3000 V, but a few hundred volts can damage a MOSFET gate or a CMOS input. Damage is not always instant: a part may work today and fail weeks later, which makes ESD bugs hard to track down.
Modules with exposed chips, such as ESP32 boards, camera modules and sensors, are especially exposed when handled by their pins.
A simple static-safe bench
- 1Put a dissipative ESD mat on the bench and connect it to ground with its cord.
- 2Wear a wrist strap connected to the mat or ground point. Its built-in resistor limits current if you touch something live; never replace the strap with a plain wire.
- 3Keep plastic, foam and synthetic clothing away from boards.
- 4Touch the mat or a grounded metal part before picking up a board.
- 5Hold boards by their edges, not the pins.
- 6Use a grounded or ESD-safe soldering station.
Storage and shipping
- Store boards and chips in metallised shielding bags or conductive foam; pink anti-static bags only stop the bag itself charging. - Do not place boards on top of a shielding bag; the outside can carry charge. - In dry seasons, a humidifier or working away from carpets helps. - When you receive parts, open the bag on your ESD mat, not on a plastic desk. These steps are cheap compared with replacing a dead module or chasing an intermittent fault.
Common mistakes to avoid
- Using a plain wire instead of a resistor wrist strap.
- Placing boards on top of shielding bags.
- Handling modules by the pins.
- Working on carpet in dry weather.
- Storing chips in ordinary plastic bags or foam.
Frequently asked questions
Do I really need an anti-static wrist strap?
For sensitive chips and modules, it is cheap insurance. Many hobbyists at least touch ground before handling parts.
What is the difference between pink and silver bags?
Silver shielding bags block external static fields; pink bags only reduce charge build-up on the bag.
Can static kill an Arduino?
It can damage the chip or USB interface, especially when touching pins directly.
Is it safe to ground myself?
Yes through a wrist strap with its built-in resistor. Never connect directly to ground with a wire.
Which parts are most sensitive?
MOSFETs, CMOS ICs, RF and Wi-Fi modules, image sensors and many LEDs.
Parts for this guide
Terms in this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.


