Component guide · Intermediate · 3 min read
P10 LED Matrix Panels
Scrolling Signs with Arduino and ESP32
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
A P10 panel is a 32 by 16 grid of LEDs spaced 10 mm apart, the building block of shop signs and scrolling message boards. Single-colour panels use a HUB12 connector and libraries such as DMD; full-colour RGB panels use HUB75 and need a fast board such as an ESP32. Panels chain together, and each needs a strong 5 V supply, often 2 to 4 A per panel at full brightness.
Key specs at a glance
- Size
- 320 x 160 mm, 32 x 16 pixels (P10)
- Single colour
- HUB12 connector, 1/4 scan, red, white, yellow, blue or green
- RGB
- HUB75 connector, needs ESP32 or similar
- Power
- 5 V; roughly 2 to 4 A per panel at full white (check the label)
- Chaining
- Output connector feeds the next panel
- Outdoor
- Outdoor-rated panels have higher brightness and better sealing
Connecting a single-colour panel
A HUB12 panel uses signals named OE (enable), A and B (row select), CLK, SCLK (latch) and R (data). An Arduino P10 adapter board or the DMD connector maps these to an Uno's SPI pins plus a few digital pins.
Feed 5 V power to the screw terminals on each panel with thick wire, not through the ribbon cable. Connect the power supply ground to the Arduino ground. Chain panels with the short ribbon from OUT to the next IN.
Software
the DMD or DMD2 library refreshes the display from a timer interrupt and draws fonts and scrolling text.
use a DMD library port for ESP32, then update the message from a web page or MQTT.
the ESP32-HUB75-MatrixPanel-DMA library drives large chains smoothly using the ESP32's I2S DMA engine.
Because the board must keep refreshing the rows, avoid long blocking code; a flicker usually means the refresh is being starved.
Power and brightness
Size the power supply for the worst case: all LEDs on. Scrolling text uses far less, but plan for headroom. Brightness control through the OE pin with PWM saves power and is easier on the eyes at night. For outdoor signs, use outdoor-rated panels, a ventilated waterproof enclosure and a supply rated for the climate. See the power supply sizing calculator.
Try it: Power supply sizing calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Powering panels through the ribbon cable.
- An undersized 5 V supply causing flicker and resets.
- Mixing HUB12 and HUB75 panels or libraries.
- Blocking code that starves the refresh interrupt.
- No shared ground between supply and controller.
Frequently asked questions
What does P10 mean?
The pixel pitch: 10 mm between LED centres.
How many P10 panels can an Arduino Uno drive?
A few single-colour panels; for larger signs use an ESP32 or a dedicated controller card.
Can I control the sign from my phone?
Yes, with an ESP32 serving a web page, Bluetooth, or a commercial Wi-Fi controller card.
What power supply do I need?
5 V at about 2 to 4 A per panel for full brightness; check the panel's label.
Can I use P10 panels outdoors?
Use outdoor-rated panels, which are brighter and sealed, in a suitable enclosure.
Parts for this guide
- ₹1,100View
Calculators
Terms in this guide
Keep learning
Sources
- P10 single-colour module specification sheets
- Freetronics DMD library documentation
- ESP32-HUB75-MatrixPanel-DMA documentation
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.

