Rebuild a V6 hotend and change the nozzle the right way
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
Shop by category
Shop all componentsA probe measures the bed at a grid of points and the firmware tilts and warps the first layer to follow it. Paired with a magnetic spring-steel PEI sheet, prints stick when hot and pop off when cool. This upgrade fits most 235 x 235 mm Ender-style beds.
Unplug the printer from the mains before opening the electronics box.
Tick anything you already have and the total updates.
Magnetic base that holds the steel sheet
Double-sided PEI spring-steel sheet, 235 x 235 mm
For stubborn prints on glass; never use a blade on PEI
The pin is stuck or the cable is reversed. Check the cable and that the probe pin moves freely.
The Z offset sign is wrong or the probe is not in use when homing Z. Check the firmware settings.
Clean the PEI with isopropyl alcohol; fingerprints stop PLA sticking.
No. Level the corners roughly first; the mesh corrects small dips and tilts.
Textured hides layer lines and releases PETG well; smooth gives a glossy bottom face.
Yes, at a gentle bed temperature.
5 parts: Creality CR Touch Auto Leveling Kit, Creality Ender Soft Magnetic Sticker 235*235*1mm, Two Trees Double-Sided PEI Spring Steel Build Plate 235x235mm, Sharp Edge Scraper 2-Inch for 3D Printer Build Plates and Generic Wing Type Bed Adjusting Nut for 3D Printers (4-Pack). On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 3 hours. The build on this page has 7 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹6,676 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
How a probe mesh compensates a bed that is not flat; Setting the probe Z offset; Why PEI holds PLA and PETG when hot and releases when cool.
Unplug the printer from the mains before opening the electronics box.
Ideas that reuse this build: Rebuild the hotend and change the nozzle. They are listed under Take it further on this page.
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
A NEMA 17, a GT2 belt and an endstop make a homing axis: the same parts that move every 3D printer and plotter.
Unbox, level, slice and print: a phone stand, a cable clip and a calibration cube, with the checks that save most beginners a week.
Choose the right engineering filament for outdoor parts: a UV-stable box, a soft seal and a stiff carbon-fibre bracket.
Learning project. Check every circuit and the datasheet of each part before you power it up.