Rebuild a V6 hotend and change the nozzle the right way
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
Shop by category
Shop all componentsA diode laser burns patterns into wood and cuts thin plywood. You will set focus, run a material test grid, engrave a design and cut the coaster outlines. The honeycomb bed lets smoke escape under the work, air assist keeps the cut clean, and an enclosure with extraction keeps smoke and light contained.
Wear laser safety glasses rated for 445 to 455 nm when the enclosure is open.
Never leave a running laser unattended; keep a fire extinguisher nearby.
Do not laser PVC, vinyl or unknown plastics.
Tick anything you already have and the total updates.
Lifts the work so smoke and flame do not mark the back
Contains light and smoke, with a duct for extraction
Refocus, slow down or add a pass; check the lens is clean.
Use air assist and masking tape on the wood.
Tighten the belts and wheels.
Thin wood, card and dark acrylic. It cannot cut clear acrylic or metal.
PVC, vinyl and anything with chlorine: the fumes are toxic and corrode the machine.
Yes when the lid is open; use glasses rated for the laser's wavelength (about 450 nm).
4 parts: Two Trees TTS 55 PRO Diode Laser Engraver, Two Trees 300x300mm Honeycomb Laser Workbench Panel, Two Trees Laser Air Assist Kit with Air Pump and Two Trees Laser Engraver Enclosure with Smoke Extraction. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 3 hours. The build on this page has 6 steps.
About ₹36,015 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
Focus, power and speed; Running a material test grid; Engrave versus cut; Laser safety.
Wear laser safety glasses rated for 445 to 455 nm when the enclosure is open. Never leave a running laser unattended; keep a fire extinguisher nearby. Do not laser PVC, vinyl or unknown plastics.
Ideas that reuse this build: Make your first FDM prints. They are listed under Take it further on this page.
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
A NEMA 17, a GT2 belt and an endstop make a homing axis: the same parts that move every 3D printer and plotter.
Stop re-levelling by hand: fit a CR Touch probe and a textured PEI spring-steel sheet for first layers that just stick.
Unbox, level, slice and print: a phone stand, a cable clip and a calibration cube, with the checks that save most beginners a week.
Learning project. Check every circuit and the datasheet of each part before you power it up.