Rebuild a V6 hotend and change the nozzle the right way
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
Shop by category
Shop all componentsResin printers cure a whole layer at once with UV light through an LCD, giving detail no filament printer can match. This project covers the full workflow: levelling, supports, washing, curing and FEP film care, with standard resin for display models and an ABS-like resin for parts that must survive handling.
Wear nitrile gloves and safety glasses with resin, work with ventilation, and never pour resin or wash liquid down the drain.
Tick anything you already have and the total updates.
Release film for the vat; cut to size
Increase bottom exposure and re-level the plate.
Cure less; over-cured resin goes brittle.
Add supports at islands the slicer warns about.
Uncured resin irritates skin; always wear gloves. Cured parts are safe to handle.
Leave it in sunlight to cure the resin in it, filter the solids and dispose of them as solid waste.
Water-wash resin skips alcohol, but the wash water still contains resin and must be cured before disposal.
5 parts: ELEGOO Mars 5 3D Printer, Creality Standard Resin Plus 500g Grey, SunLu Water-Wash ABS-Like Resin Grey 1kg, Phrozen nFEP, A4 Size 290x210mm, for 5.5″ 8.9″ 3D Printer’s and HeyGears UltraCraft Wash Box for Resin 3D Printers. On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 1 day. The build on this page has 6 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹32,459 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
How MSLA printing works; Supports and hollowing; Washing and UV curing; Safe resin handling.
Wear nitrile gloves and safety glasses with resin, work with ventilation, and never pour resin or wash liquid down the drain.
Ideas that reuse this build: Make your first FDM prints. They are listed under Take it further on this page.
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
A NEMA 17, a GT2 belt and an endstop make a homing axis: the same parts that move every 3D printer and plotter.
Stop re-levelling by hand: fit a CR Touch probe and a textured PEI spring-steel sheet for first layers that just stick.
Unbox, level, slice and print: a phone stand, a cable clip and a calibration cube, with the checks that save most beginners a week.
Learning project. Check every circuit and the datasheet of each part before you power it up.