Rebuild a V6 hotend and change the nozzle the right way
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
Shop by category
Shop all componentsYou can print two colours on any printer by pausing at the layer where the letters start and loading a new spool. This plate uses white PLA+ for the base and a tri-colour silk PLA for the letters, which shifts colour as you move around it. With an AMS-style unit the same file swaps automatically.
The hotend runs at 200 to 300 °C. Do hot work with tweezers and gloves, and switch the printer off before you touch wiring.
Tick anything you already have and the total updates.
Spare hub for owners of an AMS Lite who want automatic swaps
Purge more filament before resuming.
Wipe the nozzle and make sure the pause retracts before parking.
Print it a little slower and hotter as the spool label suggests.
Yes, add a pause at each colour layer.
Yes; Marlin and Klipper printers support M600 or a pause macro.
Each strand carries three colours side by side, so the letters change colour as you view them from different angles.
4 parts: Bambu Lab A1 Mini 3D Printer, Numakers Tri-Color Silk PLA Filament 1.75mm 1kg, Numakers PLA+ 1.75mm Bone White Filament 1kg and Bambu Lab AMS Lite Filament Hub. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 2 hours. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹23,853 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
Inserting a colour change at a layer in the slicer; Purging the old colour; How silk and multicolour filaments look.
The hotend runs at 200 to 300 °C. Do hot work with tweezers and gloves, and switch the printer off before you touch wiring.
Ideas that reuse this build: Set up a new FDM printer. They are listed under Take it further on this page.
Fix clogs and leaks for good: strip, clean and rebuild a V6-style hotend, then hot-tighten a fresh nozzle.
A NEMA 17, a GT2 belt and an endstop make a homing axis: the same parts that move every 3D printer and plotter.
Stop re-levelling by hand: fit a CR Touch probe and a textured PEI spring-steel sheet for first layers that just stick.
Unbox, level, slice and print: a phone stand, a cable clip and a calibration cube, with the checks that save most beginners a week.
Learning project. Check every circuit and the datasheet of each part before you power it up.