Shop by category
Shop all componentsAnalog circuits
Use a 4-terminal (Kelvin) shunt or measure right at the resistor pads, because wire and solder resistance is comparable to a milliohm shunt.
R = V sense ÷ I maxP = I² × RGain = V ADC ÷ V senseI = V measured ÷ RFor 10 A with a 75 mV shunt: R = 0.075 ÷ 10 = 7.5 mΩ, 0.75 W at full current (use a 2 W part). To fill a 3.3 V ADC you need a gain of 44. A reading of 30 mV means 4 A.
A shunt is a very small, precise resistor placed in the current path. The voltage across it is proportional to the current, so you can measure current by measuring millivolts. Ready-made modules such as the INA219 and INA226 do the amplification and conversion for you.
A bigger shunt gives a bigger signal but wastes voltage and heat. Choose the sense voltage so that the signal at maximum current is at least 50 mV; for very low currents, use a higher value and a precision amplifier.
R = V sense ÷ I max. For 10 A and 100 mV full scale, use 10 mΩ.
P = I² × R. A 10 mΩ shunt at 10 A dissipates 1 W, so choose at least a 2 W part.
A lower voltage wastes less power and affects the circuit less, but needs an amplifier such as an INA219 to read accurately.
R = V sense ÷ I max; P = I² × R; Gain = V ADC ÷ V sense; I = V measured ÷ R.
For 10 A with a 75 mV shunt: R = 0.075 ÷ 10 = 7.5 mΩ, 0.75 W at full current (use a 2 W part). To fill a 3.3 V ADC you need a gain of 44. A reading of 30 mV means 4 A.
Geekobot builds that use it include Solar panel power meter, Standby power finder for DC adapters, DC motor load colour ring and Power-bank fuel gauge colour ring. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators