Shop by category
Shop all componentsAnalog circuits
Rs = (Vin − Vz) ÷ (I load + I z min)P R = (Vin − Vz)² ÷ RsP Z (no load) = Vz × (Vin − Vz) ÷ Rs12 V in, 5.1 V Zener, 20 mA load, 5 mA minimum: Rs = 6.9 ÷ 0.025 = 276 Ω, use 270 Ω. With no load the Zener burns 5.1 × 6.9 ÷ 270 = 130 mW.
A Zener diode in reverse breakdown holds a nearly constant voltage. With a series resistor it makes a simple regulator or voltage reference, and it is often used to clamp inputs and protect microcontroller pins.
The resistor must pass enough current for the load plus a few milliamps for the Zener at the lowest input voltage. The Zener’s worst case is when the load is disconnected and it takes all the current. For more than about 50 mA, a linear regulator like the 7805 or a buck converter is far better.
Rs = (Vin − Vz) ÷ (I load + I z min). Size it so the Zener still gets a few milliamps at the heaviest load.
Check the no-load case: all the current then goes through the Zener. P = Vz × (Vin − Vz) ÷ Rs, and pick a part with at least twice that rating.
Only for small loads like a reference or a few milliamps. For real loads use a linear regulator or a buck converter.
Rs = (Vin − Vz) ÷ (I load + I z min); P R = (Vin − Vz)² ÷ Rs; P Z (no load) = Vz × (Vin − Vz) ÷ Rs.
12 V in, 5.1 V Zener, 20 mA load, 5 mA minimum: Rs = 6.9 ÷ 0.025 = 276 Ω, use 270 Ω. With no load the Zener burns 5.1 × 6.9 ÷ 270 = 130 mW.
Geekobot builds that use it include Winter humidifier controller, Silent doorbell with a vibration bracelet, Door knock light for the hard of hearing and Sound-to-light alert for deaf and hard-of-hearing users. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators