Shop by category
Shop all componentsAnalog circuits
P conduction = I² × Rds(on) × hot factor × dutyP switching = ½ × V × I × (t r + t f) × fTj = Ta + P × θ ja5 A at 12 V and 50% duty with a 20 mΩ MOSFET (1.5× hot) switching at 20 kHz with 100 ns edges: conduction 0.375 W, switching 0.06 W, total 0.435 W, so a TO-220 reaches about 67 °C.
A MOSFET used as a switch wastes power in two ways: while it is fully on (its small resistance times the current squared) and during the brief moments of switching, when it has both voltage across it and current through it.
At low frequency the conduction loss dominates, so choose a low Rds(on). At high frequency or with slow gate drive the switching loss takes over; a proper gate driver and a gate resistor of 10–100 Ω reduce it. For motor and LED strip drivers, use a logic-level MOSFET if the gate is driven from 3.3 V or 5 V.
Conduction loss is I² × Rds(on), plus switching loss at high PWM frequencies.
Rds(on) rises with temperature, often by 1.5 times at 100 °C. The calculator includes a hot factor for this.
If total loss is under about 1 W in TO-220, usually not. Above that, check the junction temperature with the calculator.
P conduction = I² × Rds(on) × hot factor × duty; P switching = ½ × V × I × (t r + t f) × f; Tj = Ta + P × θ ja.
5 A at 12 V and 50% duty with a 20 mΩ MOSFET (1.5× hot) switching at 20 kHz with 100 ns edges: conduction 0.375 W, switching 0.06 W, total 0.435 W, so a TO-220 reaches about 67 °C.
Geekobot builds that use it include Winter humidifier controller, DC fan speed controller, Temperature-controlled laptop stand fan and Pico automatic grow light with a BH1750 (MicroPython). Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators