Shop by category
Shop all componentsOhm’s law & basics
P = I² × RP = V² ÷ RP = V × IRating ≥ 2 × P50 mA through 100 Ω: P = 0.05² × 100 = 0.25 W. That is exactly a ¼ W resistor’s limit, so choose ½ W.
Every resistor converts the power it drops into heat. Resistors are sold by the power they can shed safely: ⅛ W and ¼ W for signal work, ½ W to 2 W for LED and sensor circuits, and wire-wound or aluminium-clad parts for 5 W and up.
A good rule is to buy a rating at least twice the power you calculate. Resistors running near their limit get hot, drift in value and can scorch a PCB. If the power is high, consider a switching regulator instead of burning the energy in a resistor.
Work out the power with P = I² × R or P = V² ÷ R, then pick a rating at least twice that. A resistor dissipating 0.2 W should be a 0.5 W part, not a 0.25 W one.
It is turning electrical power into heat. Close to its rated wattage a resistor can run well above 100 °C, which is normal for the part but can damage nearby plastic or the PCB.
Usually yes. A 20 mA LED with a 150 Ω resistor dissipates about 0.06 W, far below 0.25 W. Check with the calculator when the supply is 12 V or higher.
P = I² × R; P = V² ÷ R; P = V × I; Rating ≥ 2 × P.
50 mA through 100 Ω: P = 0.05² × 100 = 0.25 W. That is exactly a ¼ W resistor’s limit, so choose ½ W.
Geekobot builds that use it include Garage parking assistant with a TF-Luna LiDAR and traffic-light LEDs, Plant watering reminder with a capacitive soil moisture sensor, Digital kitchen scale with a load cell, plus a force-pad game and Classroom noise meter with a recorded voice reminder. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators