Shop by category
Shop all componentsOhm’s law & basics
Microcontrollers can cap brightness in software (for example FastLED setMaxPowerInVoltsAndMilliamps) to fit a smaller supply.
I max = LEDs × mA per LED ÷ 1000P = V × ISupply ≥ 1.2 × I max120 WS2812B LEDs × 60 mA = 7.2 A at full white, 36 W at 5 V. Choose a 5 V supply rated 9 A or more (10 A is a standard size), or limit brightness to 50% and use 5 V 5 A.
Addressable RGB LEDs like WS2812B draw up to about 20 mA per colour channel, so roughly 60 mA per LED at full white. Long strips add up fast, and thin strip copper drops voltage, which shows as yellowing at the far end.
Size the supply for the worst case you will actually display, add 20% headroom, and feed power into the strip at both ends or every one to two metres. Put a 1000 µF capacitor across the supply at the strip and a 330 Ω resistor in the data line.
Up to about 60 mA per LED at full white, so 60 LEDs can draw 3.6 A. Real animations usually use a third of that or less.
Yes. On 5 V strips the voltage drops along the copper, so feed power at both ends or every 1 to 2 metres to stop the far end turning orange.
Take the maximum current from the calculator and add about 20 % headroom. For 3.6 A at 5 V, a 5 V 5 A supply is a safe choice.
I max = LEDs × mA per LED ÷ 1000; P = V × I; Supply ≥ 1.2 × I max.
120 WS2812B LEDs × 60 mA = 7.2 A at full white, 36 W at 5 V. Choose a 5 V supply rated 9 A or more (10 A is a standard size), or limit brightness to 50% and use 5 V 5 A.
Geekobot builds that use it include Wardrobe light that turns on with the door, Night sky twinkling star ceiling, Diya flicker LED strip for Diwali and Under-bed motion night light. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators