Component guide · Intermediate · 6 min read
BLHeli_32 and AM32 4-in-1 ESCs

T-Motor F55A, F66A, P60A, V50A and CINE55A 8-in-1, Foxeer Reaper, Holybro Tekko32, iFlight BLITZ, DYS ARIA, Zerodrag and BotLab
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
32-bit 4-in-1 ESCs run BLHeli_32 or the open-source AM32 firmware. They support higher PWM frequencies, ESC telemetry (temperature, current and RPM per motor), bidirectional DShot and, on many boards, 8S batteries for long-range and cinelifter builds. AM32 is now the choice for new boards because BLHeli_32 development has stopped.
Key specs at a glance
- Current
- 45A to 80A per motor
- Voltage
- 3S to 8S (check each board)
- Firmware
- BLHeli_32 or AM32
- Protocol
- DShot300/600, bidirectional, telemetry
- Mounting
- 20x20 or 30.5x30.5 mm
- Special
- 8-in-1 CINE55A for X8 cinelifters
This part can carry many amps. Use wire thick enough for the current, put a fuse close to the battery, check that connectors are rated for the load and give drivers and motors room to cool. A short at these currents melts wires in seconds.
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1T-Motor F55A PRO III 55A 3-8S 4-in-1 ESC₹14,699
Option 2T-Motor F55A Pro II 6S 4-in-1 55A BLHeli_32 ESC₹11,439
Option 3T-Motor F66A MINI 6S 4-in-1 66A BLHeli_32 FPV ESC₹18,779
Option 4T-Motor F66A Mini 66A 3-6S BLHeli_32 4-in-1 ESC₹14,749
Option 5T-Motor P60A V2 60A 3-6S BLHeli_32 4-in-1 ESC₹10,759
Option 6T-Motor V45A LITE 4-in-1 ESC 45A 3-6S₹5,709
What the FPV 4-in-1 ESCs (BLHeli_32 and AM32, 32-bit) is
FPV 4-in-1 ESCs with BLHeli_32 or AM32 firmware are 32-bit ESCs with bidirectional DShot, current telemetry and adjustable PWM frequency.
Telemetry lets Betaflight show each motor's temperature and current in the OSD and logs, useful for spotting a failing motor. AM32 boards are configured in the AM32 web configurator through the flight controller's passthrough.
The T-Motor CINE55A drives eight motors for coaxial X8 cinema drones. 8S boards (Foxeer Reaper, F55A Pro III, iFlight E80, DYS 65A) suit 7 to 10 inch long-range quads.
FPV 4-in-1 ESCs (BLHeli_32 and AM32, 32-bit) pinout
The pins on the FPV 4-in-1 ESCs (BLHeli_32 and AM32, 32-bit) and what each one does.
| Pin | Function |
|---|---|
| Battery pads (+ / -) | Main LiPo input; solder the XT60 lead and the capacitor here |
| Motor pads M1 to M4 | Three pads per motor; any order, fix direction in software |
| FC connector (8-pin) | VBAT, GND, current, telemetry and four signal lines to the flight controller |
| Low-ESR capacitor | Soaks up voltage spikes; always fit one across the battery pads |
- Battery pads (+ / -)
- Main LiPo input; solder the XT60 lead and the capacitor here
- Motor pads M1 to M4
- Three pads per motor; any order, fix direction in software
- FC connector (8-pin)
- VBAT, GND, current, telemetry and four signal lines to the flight controller
- Low-ESR capacitor
- Soaks up voltage spikes; always fit one across the battery pads
Wiring the FPV 4-in-1 ESCs (BLHeli_32 and AM32, 32-bit)
Compare the pin order printed on the ESC and flight controller before plugging the 8-pin cable; brands differ. Use a smoke stopper for the first power-up, with props off.
| FPV 4-in-1 ESCs (BLHeli_32 and AM32, 32-bit) pin | Connection | Note |
|---|---|---|
| Battery | XT60 lead + capacitor to the battery pads | Thick wire, short as possible |
| Flight controller | 8-pin cable (check pin order) | Wrong order can kill both boards |
| Motors | Three wires each to M1 to M4 | Swap direction in BLHeli or Betaflight |
- Battery
- Connection:
- XT60 lead + capacitor to the battery pads
- Note:
- Thick wire, short as possible
- Flight controller
- Connection:
- 8-pin cable (check pin order)
- Note:
- Wrong order can kill both boards
- Motors
- Connection:
- Three wires each to M1 to M4
- Note:
- Swap direction in BLHeli or Betaflight
Example code
For AM32 boards use the AM32 configurator (am32.ca) through Betaflight passthrough. Keep all four ESCs on the same firmware version.
# In Betaflight Configurator > CLI
set motor_pwm_protocol = DSHOT600
set dshot_bidir = ON # needs Bluejay (BLHeli_S) or BLHeli_32 / AM32
set motor_poles = 14 # count the magnets on your motor bell
save
# Motor direction (props off, battery on):
# Motors tab > Motor direction > pick motor > reverse
# Or in the ESC: BLHeli Configurator / ESC-Configurator > Motor DirectionSetup and tuning
BLHeli_32 is closed source and no longer developed; AM32 is open source and can be flashed on supported ESC targets.
wire the current sensor pad to the flight controller and set the scale in Betaflight.
solder a low-ESR capacitor at the battery pads.
compare continuous current with your motors' full-throttle draw, not the burst number.
enable bidirectional DShot for RPM filtering.
check motor order and direction with props off.
What you need
Shop this list20 of 20 found in our store · ₹2,37,327
T-Motor F55A PRO III 55A 3-8S 4-in-1 ESC: the part this guide coversT-Motor F55A PRO III 55A 3-8S 4-in-1 ESC₹14,699
T-Motor F55A Pro II 6S 4-in-1 55A BLHeli32 ESC: another version this guide coversT-Motor F55A Pro II 6S 4-in-1 55A BLHeli_32 ESC₹11,439
T-Motor F66A MINI 6S 4-in-1 66A BLHeli32 FPV ESC: another version this guide coversT-Motor F66A MINI 6S 4-in-1 66A BLHeli_32 FPV ESC₹18,779
T-Motor F66A Mini 66A 3-6S BLHeli32 4-in-1 ESC: another version this guide coversT-Motor F66A Mini 66A 3-6S BLHeli_32 4-in-1 ESC₹14,749
T-Motor P60A V2 60A 3-6S BLHeli32 4-in-1 ESC: another version this guide coversT-Motor P60A V2 60A 3-6S BLHeli_32 4-in-1 ESC₹10,759
T-Motor V45A LITE 4-in-1 ESC 45A 3-6S: another version this guide coversT-Motor V45A LITE 4-in-1 ESC 45A 3-6S₹5,709
T-Motor V50A 50A 4-in-1 32-Bit BLHeli32 ESC 3-6S: another version this guide coversT-Motor V50A 50A 4-in-1 32-Bit BLHeli_32 ESC 3-6S₹8,479
T-Motor Velox V50A SE 6S 4-in-1 32-Bit 50A ESC: another version this guide coversT-Motor Velox V50A SE 6S 4-in-1 32-Bit 50A ESC₹6,969
T-Motor C80A 4-in-1 80A 4-8S BLHeli32 FPV ESC: another version this guide coversT-Motor C80A 4-in-1 80A 4-8S BLHeli_32 FPV ESC₹37,239
T-Motor CINE55A 8S 8-in-1 32Bit ESC 55A: another version this guide coversT-Motor CINE55A 8S 8-in-1 32Bit ESC 55A₹32,169
Foxeer Reaper F4 60A Slim 3-8S 4-in-1 BLHeli32 ESC: another version this guide coversFoxeer Reaper F4 60A Slim 3-8S 4-in-1 BLHeli32 ESC₹9,029
Foxeer Reaper F4 65A BLHeli32 4-in-1 ESC 3-8S: another version this guide coversFoxeer Reaper F4 65A BLHeli_32 4-in-1 ESC 3-8S₹10,979
Foxeer Reaper F4 Mini 60A 3-8S 4-in-1 ESC: another version this guide coversFoxeer Reaper F4 Mini 60A 3-8S 4-in-1 ESC₹9,029
Holybro Tekko32 F4 4-in-1 50A BLHeli32 ESC: another version this guide coversHolybro Tekko32 F4 4-in-1 50A BLHeli_32 ESC₹9,209
Holybro Tekko32 F4 Metal 4in1 65A ESC: another version this guide coversHolybro Tekko32 F4 Metal 4in1 65A ESC₹10,649
SpeedyBee BL32 50A 4-in-1 ESC: another version this guide coversSpeedyBee BL32 50A 4-in-1 ESC₹5,320
DYS ARIA 45A 4-in-1 BLHeli32 ESC 2-6S: another version this guide coversDYS ARIA 45A 4-in-1 BLHeli_32 ESC 2-6S₹5,369
DYS ARIA 60A 4-in-1 BLHeli32 Brushless ESC: another version this guide coversDYS ARIA 60A 4-in-1 BLHeli_32 Brushless ESC₹6,599
DYS 65A AM32 F4 4-in-1 ESC 2-8S: another version this guide coversDYS 65A AM32 F4 4-in-1 ESC 2-8S₹5,565
JHEMCU BLHeli32 40A 4-in-1 3-6S FPV Drone ESC: another version this guide coversJHEMCU BLHeli_32 40A 4-in-1 3-6S FPV Drone ESC₹4,589
Alternatives and when to choose them
- BLHeli_S 4-in-1 ESCs: cheaper 8-bit boards.
- FC and ESC stacks: matched pairs.
- Heavy-lift ESCs: big drones.
Common mistakes to avoid
- Flashing the wrong AM32 target.
- Skipping the capacitor.
- Running above the continuous current rating.
- Testing motor order with props on.
Frequently asked questions
What is the difference between BLHeli_32 and AM32?
Both run on 32-bit ESCs; AM32 is open source and still developed, BLHeli_32 has stopped.
Can I flash AM32 on any 32-bit ESC?
Only on supported targets. Pick the exact target from the AM32 list or you can brick the ESC.
Do I need bidirectional DShot?
It sends RPM data back so Betaflight can filter motor noise and fly smoother.
Why add a capacitor to a 32-bit ESC?
It protects the ESC from voltage spikes and reduces video noise.
How do I read battery current in Betaflight?
Wire the current pad to the flight controller and set the current sensor scale.
Parts for this guide
- ₹14,699View
- ₹11,439View
- ₹18,779View
- ₹14,749View
- ₹10,759View
- ₹5,709View
- ₹8,479View
- ₹6,969View
- ₹37,239View
- ₹32,169View
- ₹9,029View
- ₹10,979View
- ₹9,029View
- ₹9,209View
- ₹10,649View
- ₹5,320View
- ₹5,369View
- ₹6,599View
- ₹5,565View
- ₹4,589View
- ₹2,519View
- ₹5,299View
- ₹7,013View
- ₹11,489View
- ₹5,459View
- ₹31,149View
- ₹6,979View
- ₹4,839View
- ₹609View
- ₹979View
- ₹1,392View
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.











