Component guide · Beginner · 4 min read
GSM, 4G LTE and 5G Antennas

Rubber Duck and Stub, Magnetic Base with RG58 Cable, Sticker and Flat PCB, Foldable 6dBi, Sucker 7dBi, LTE/5G/Wi-Fi and GNSS+LTE Combination Antennas
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
A cellular module only works as well as its antenna. Small stub and rubber duck antennas screw straight onto an SMA socket. Magnetic base antennas on a 3 or 5 m RG58 cable let you put the antenna on a metal roof or outside a panel while the module stays inside. Sticker and PCB antennas hide inside a plastic case. Pick one that covers the bands of your module, 2G, 4G or 5G.
Key specs at a glance
- Bands
- 2G 900/1800 MHz; LTE 700-2700 MHz; 5G sub-6 GHz on wideband models
- Gain
- 2 to 7 dBi by model
- Connector
- SMA male, RP-SMA or u.FL/IPEX by model
- Cable
- None (stub) or 1 to 5 m RG58 / RG174
- Mounting
- Direct, magnetic base, sticker, foldable or sucker
- Impedance
- 50 ohm
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 13dBi GSM Sticker Antenna with Extension Cable₹83
Option 25dBi GSM Magnetic Antenna, 3 m Cable₹85
Option 3GSM / GPRS / 3G Flat PCB Antenna (Built-in Type)₹25
Option 4GSM 3 dBi Magnetic Spring Antenna, 900/1800 MHz₹96
Option 5GSM Antenna SMA 5cm 900-1800MHz 2dBi₹46
Option 6GSM Foldable Antenna 6dBi with Cable (TS-JB-440)₹125
What the GSM, 4G LTE and 5G antennas: stubs, magnetic, sticker, PCB and combo antennas is
GSM, LTE and 5G antennas connect to cellular modems like the SIM800, SIM7600 and Quectel modules, improving signal for IoT devices, routers and trackers.
Check the band list first: an old 900/1800 MHz GSM antenna works for SIM800 but loses a lot of signal on 4G bands like 2300 MHz (band 40) used in India. For SIM7600, EC200U and A7672 modules pick an LTE wideband antenna, and a 5G/LTE antenna for 5G HATs.
Then match the connector. Most modules have a small u.FL (IPEX) socket, so you need a u.FL to SMA pigtail unless the board already has SMA. Keep cable runs short: thin RG174 loses noticeably more than RG58. Mount the antenna upright, away from metal and away from the module's own switching regulator. Combo GNSS+LTE antennas have two cables, one to each port.
GSM, 4G LTE and 5G antennas: stubs, magnetic, sticker, PCB and combo antennas pinout
The pins on the GSM, 4G LTE and 5G antennas: stubs, magnetic, sticker, PCB and combo antennas and what each one does.
| Pin | Function |
|---|---|
| SMA male | Screws onto an SMA female socket on the board |
| RP-SMA | Reverse polarity; common on Wi-Fi gear, check before buying |
| u.FL / IPEX | Tiny snap connector on most modules |
| Main / ANT | Primary LTE port on the module |
| DIV / AUX | Diversity port on 4G modules |
| GNSS | GPS port, used by combo antennas |
- SMA male
- Screws onto an SMA female socket on the board
- RP-SMA
- Reverse polarity; common on Wi-Fi gear, check before buying
- u.FL / IPEX
- Tiny snap connector on most modules
- Main / ANT
- Primary LTE port on the module
- DIV / AUX
- Diversity port on 4G modules
- GNSS
- GPS port, used by combo antennas
Wiring the GSM, 4G LTE and 5G antennas: stubs, magnetic, sticker, PCB and combo antennas
Never transmit without an antenna connected; a 2W GSM burst into an open port can damage the module's power amplifier.
| GSM, 4G LTE and 5G antennas: stubs, magnetic, sticker, PCB and combo antennas pin | Connection | Note |
|---|---|---|
| Antenna SMA | Module SMA or pigtail | Finger tight, no wrench |
| LTE cable | Module MAIN port | Not the GNSS port |
| Second antenna | DIV port | Improves 4G throughput |
| GNSS lead (combo) | GNSS port | Sky view needed |
- Antenna SMA
- Connection:
- Module SMA or pigtail
- Note:
- Finger tight, no wrench
- LTE cable
- Connection:
- Module MAIN port
- Note:
- Not the GNSS port
- Second antenna
- Connection:
- DIV port
- Note:
- Improves 4G throughput
- GNSS lead (combo)
- Connection:
- GNSS port
- Note:
- Sky view needed
Example code
Move the antenna and re-read CSQ or RSRP; a few centimetres or a window position often changes the result by several steps.
AT+CSQ
+CSQ: 22,0 (0-31; above 15 is good, 99 = no signal)
AT+CESQ (on LTE modules, gives RSRP and RSRQ)
AT+QCSQ (Quectel modules: shows LTE RSRP, SINR)
Rule of thumb for LTE RSRP:
better than -90 dBm excellent
-90 to -105 dBm fine
worse than -110 dBm move or raise the antennaSetup and tuning
choose an antenna that covers your carrier's bands, such as 700 to 2700 MHz for LTE, or up to 6 GHz for 5G.
match u.FL, SMA or SMA-RP; use a short low-loss cable.
LTE Cat-4 and 5G modems have main and diversity ports; connect both for best speed.
mount outside metal boxes, ideally vertical and high.
it can damage the modem.
What you need
Shop this list14 of 14 found in our store · ₹5,173
3dBi GSM Sticker Antenna with Extension Cable: the part this guide covers3dBi GSM Sticker Antenna with Extension Cable₹83
5dBi GSM Magnetic Antenna, 3 m Cable: another version this guide covers5dBi GSM Magnetic Antenna, 3 m Cable₹85
GSM / GPRS / 3G Flat PCB Antenna (Built-in Type): another version this guide coversGSM / GPRS / 3G Flat PCB Antenna (Built-in Type)₹25
GSM 3 dBi Magnetic Spring Antenna, 900/1800 MHz: another version this guide coversGSM 3 dBi Magnetic Spring Antenna, 900/1800 MHz₹96
GSM Antenna SMA 5cm 900-1800MHz 2dBi: another version this guide coversGSM Antenna SMA 5cm 900-1800MHz 2dBi₹46
GSM Foldable Antenna 6dBi with Cable (TS-JB-440): another version this guide coversGSM Foldable Antenna 6dBi with Cable (TS-JB-440)₹125
GSM Rubber Duck Antenna 2 dBi, 824-960 / 1710-1980 MHz: another version this guide coversGSM Rubber Duck Antenna 2 dBi, 824-960 / 1710-1980 MHz₹56
LWC-GSM-MM-03 GSM Antenna Stub 3.0M-RG58 SMA: another version this guide coversLWC-GSM-MM-03 GSM Antenna Stub 3.0M-RG58 SMA₹235
LWC-GSM-MM-03 GSM Antenna w/ 5m RG58 Stub Cable: another version this guide coversLWC-GSM-MM-03 GSM Antenna w/ 5m RG58 Stub Cable₹307
LWC-GSM-MM-06 GSM Antenna, 5.0M RG58 Cable w/ SMA Plug: another version this guide coversLWC-GSM-MM-06 GSM Antenna, 5.0M RG58 Cable w/ SMA Plug₹301
SAM Head Sucker GSM Antenna 7dBi SMA Male w/ Magnetic Base: another version this guide coversSAM Head Sucker GSM Antenna 7dBi SMA Male w/ Magnetic Base₹120
JC Antenna LTE, 5G and Wi-Fi Antenna: another version this guide coversJC Antenna LTE, 5G and Wi-Fi Antenna₹2,700
Waveshare 4G LTE SMA Antenna: another version this guide coversWaveshare 4G LTE SMA Antenna₹150
JC Antenna GNSS + LTE Combination Antenna: another version this guide coversJC Antenna GNSS + LTE Combination Antenna₹845
Alternatives and when to choose them
- Choosing an antenna: gain and VSWR explained.
- RF antenna connectors: SMA, RP-SMA, u.FL.
- SIM7600 4G module: a module these antennas suit.
- SIM800L GSM: the classic 2G module.
Common mistakes to avoid
- Mixing up SMA and RP-SMA connectors.
- Mounting antennas inside metal boxes.
- Transmitting with no antenna attached.
- Using a narrow-band antenna for LTE.
Frequently asked questions
Which antenna do I need for a SIM7600 module?
A wideband LTE antenna on the main port, plus a second one on the diversity port.
Why is my signal weak?
The antenna is inside a metal box or the cable is long; move it outside.
What is the difference between SMA and RP-SMA?
They swap the centre pin; the wrong one connects loosely and fails.
Do I need two antennas for LTE?
For best speed yes; one works but with less throughput.
Can I power up a modem without an antenna?
Avoid it, because transmitting without a load can damage the RF stage.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.
