Component guide · Advanced · 5 min read
Holybro Pixhawk 4 and Pixhawk 5X Autopilots

Pixhawk 4 with PM02 or PM07, Pixhawk 4 Mini, 5X Standard v2A and v2B and 5X Mini Sets with M9N or M10 GPS
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
The Pixhawk 4 and Pixhawk 5X are Holybro's FMUv5 and FMUv5X autopilots, used on survey, research and student drones. They run ArduPilot or PX4. The Pixhawk 4 comes with a PM02 (up to 12S) or PM07 (up to 14S, with a power distribution board) power module; the 5X adds triple redundant IMUs, Ethernet and a modular baseboard. Sets with M9N or M10 GPS are ready to fly.
Key specs at a glance
- Processor
- STM32F765 (FMUv5 / v5X)
- IMUs
- 2 (Pixhawk 4), 3 isolated and heated (5X)
- Firmware
- ArduPilot or PX4
- Power module
- PM02 12S, PM07 14S with PDB, PM02D digital
- Outputs
- 8 IO + 8 FMU PWM (Pixhawk 4)
- Extras
- Ethernet on 5X; aluminium or plastic case
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1Holybro Pixhawk 4 Autopilot Flight Controller – Plastic Case₹15,899
Option 2Holybro Pixhawk 4 PX4 Flight Controller (without GPS)₹33,733
Option 3Holybro Pixhawk 4 Mini Autopilot Flight Controller₹29,999
Option 4Holybro Pixhawk 4 & PM02 12S Power Module Set₹21,589
Option 5Holybro Pixhawk 4 & PM02 12S Power Module Set – Aluminum Case₹23,119
Option 6Holybro Pixhawk 4 & PM07 14S Power Module Set₹23,879
What the Holybro Pixhawk 4, 4 Mini and 5X autopilots is
The Holybro Pixhawk 4 and Pixhawk 5X are open-standard flight controllers running PX4 or ArduPilot for drones, planes, rovers and boats; the 5X adds vibration-isolated, triple-redundant IMUs.
Pick a set by what you already have: FC only, FC plus power module, or the full set with GPS. v2A and v2B 5X sets differ in the baseboard and power module (analog or digital).
The Pixhawk 4 Mini has fewer outputs and suits small frames. The Pix32 v5 Mini baseboard lets the FMU module fit tight builds.
Holybro Pixhawk 4, 4 Mini and 5X autopilots pinout
The pins on the Holybro Pixhawk 4, 4 Mini and 5X autopilots and what each one does.
| Pin | Function |
|---|---|
| POWER1 / POWER2 | From the power module: 5V for the FC plus battery voltage and current |
| GPS1 / GPS2 | GPS, compass, safety switch and buzzer on one connector |
| TELEM1 / TELEM2 | Telemetry radio, companion computer or OSD |
| RC IN | SBUS, PPM, CRSF or DSM receiver |
| MAIN / AUX OUT (I/O PWM) | ESC and servo signals |
| CAN1 / CAN2 | DroneCAN GPS, ESCs and sensors |
- POWER1 / POWER2
- From the power module: 5V for the FC plus battery voltage and current
- GPS1 / GPS2
- GPS, compass, safety switch and buzzer on one connector
- TELEM1 / TELEM2
- Telemetry radio, companion computer or OSD
- RC IN
- SBUS, PPM, CRSF or DSM receiver
- MAIN / AUX OUT (I/O PWM)
- ESC and servo signals
- CAN1 / CAN2
- DroneCAN GPS, ESCs and sensors
Wiring the Holybro Pixhawk 4, 4 Mini and 5X autopilots
Mount the autopilot near the centre of gravity with the arrow forward on the supplied foam or damping mount. Never power the servo rail from the power module; use a separate BEC if servos need power.
| Holybro Pixhawk 4, 4 Mini and 5X autopilots pin | Port on the autopilot | Note |
|---|---|---|
| Power module | POWER1 | Battery through the PM to the PDB |
| GPS | GPS1 | Arrow forward, away from wires |
| Receiver | RC IN | SBUS or CRSF (set SERIAL protocol) |
| ESCs | MAIN OUT 1 to 4 (or FMU outputs) | Signal and GND only |
| Telemetry | TELEM1 | Air radio |
- Power module
- Port on the autopilot:
- POWER1
- Note:
- Battery through the PM to the PDB
- GPS
- Port on the autopilot:
- GPS1
- Note:
- Arrow forward, away from wires
- Receiver
- Port on the autopilot:
- RC IN
- Note:
- SBUS or CRSF (set SERIAL protocol)
- ESCs
- Port on the autopilot:
- MAIN OUT 1 to 4 (or FMU outputs)
- Note:
- Signal and GND only
- Telemetry
- Port on the autopilot:
- TELEM1
- Note:
- Air radio
Example code
PX4 users do the same in QGroundControl. Re-do the compass calibration whenever wiring near the GPS changes.
1. Connect USB, Setup > Install Firmware > pick Copter, Plane or Rover
2. Mandatory Hardware:
Frame Type -> e.g. Quad X
Accel Calibration -> level, left, right, nose down, nose up, back
Compass -> Start, rotate the drone in all directions
Radio Calibration -> move all sticks and switches to their ends
Flight Modes -> Stabilize, AltHold, Loiter, RTL on a 3- or 6-way switch
ESC Calibration -> props off, follow the on-screen steps
Failsafe -> battery and radio failsafe to RTL or Land
3. Config > Full Parameter List: SERIAL1_PROTOCOL = 2 (MAVLink2) for telemetry
4. Test arm with props OFF, then hover test in an open fieldSetup and tuning
flash PX4 with QGroundControl or ArduPilot with Mission Planner.
feed the autopilot through the matching power module (PM07 for Pixhawk 4, PM02D for 5X).
mount with the arrow forward, near the centre of gravity, on the supplied foam.
run accelerometer, compass, radio and ESC calibration in the ground station.
connect motors to MAIN or I/O outputs per the airframe diagram.
set failsafes for RC loss, low battery and geofence before flight.
What you need
Shop this list20 of 20 found in our store · ₹6,17,054
Holybro Pixhawk 4 Autopilot Flight Controller – Plastic Case: the part this guide coversHolybro Pixhawk 4 Autopilot Flight Controller – Plastic Case₹15,899
Holybro Pixhawk 4 PX4 Flight Controller (without GPS): another version this guide coversHolybro Pixhawk 4 PX4 Flight Controller (without GPS)₹33,733
Holybro Pixhawk 4 Mini Autopilot Flight Controller: another version this guide coversHolybro Pixhawk 4 Mini Autopilot Flight Controller₹29,999
Holybro Pixhawk 4 & PM02 12S Power Module Set: another version this guide coversHolybro Pixhawk 4 & PM02 12S Power Module Set₹21,589
Holybro Pixhawk 4 & PM02 12S Power Module Set – Aluminum Case: another version this guide coversHolybro Pixhawk 4 & PM02 12S Power Module Set₹21,589
Holybro Pixhawk 4 & PM07 14S Power Module Set: another version this guide coversHolybro Pixhawk 4 & PM07 14S Power Module Set₹23,879
Holybro Pixhawk 4 Flight Controller & PM07 14S Power Module Set – Aluminum Case: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM07 14S Power Module Set – Aluminum Case₹25,409
Holybro Pixhawk 4 Flight Controller & PM07 14S & M9N GPS Set – Plastic Case: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM07 14S & M9N GPS Set – Plastic Case₹26,869
Holybro Pixhawk 4 Flight Controller & PM07 14S Power Module & M9N GPS Set: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM07 14S Power Module & M9N GPS Set₹33,809
Holybro Pixhawk 4 Flight Controller & PM07 14S Power Module & M10 GPS Set: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM07 14S Power Module & M10 GPS Set₹29,799
Holybro Pixhawk 4 Flight Controller & PM07 14S & M10 GPS Set: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM07 14S & M10 GPS Set₹31,329
Holybro Pixhawk 4 Flight Controller & PM02 12S Power Module & M9N GPS Set: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM02 12S Power Module & M9N GPS Set₹31,329
Holybro Pixhawk 4 Flight Controller & PM02 12S Power Module & M10 GPS Set: another version this guide coversHolybro Pixhawk 4 Flight Controller & PM02 12S Power Module & M10 GPS Set₹23,839
Holybro Pixhawk 5X Standard Set v2A+M10 GPS: another version this guide coversHolybro Pixhawk 5X Standard Set v2A+M10 GPS₹44,889
Holybro Pixhawk 5X Standard Set v2A+M9N GPS: another version this guide coversHolybro Pixhawk 5X Standard Set v2A+M9N GPS₹46,999
Holybro Pixhawk 5X Standard Set v2B+M10 GPS: another version this guide coversHolybro Pixhawk 5X Standard Set v2B+M10 GPS₹44,889
Holybro Pixhawk 5X Standard Set v2B+M9N GPS: another version this guide coversHolybro Pixhawk 5X Standard Set v2B+M9N GPS₹46,999
Holybro Pixhawk 5X Mini Set with M10 GPS: another version this guide coversHolybro Pixhawk 5X Mini Set with M10 GPS₹39,739
Holybro Pixhawk 5X Mini Set with M9N GPS: another version this guide coversHolybro Pixhawk 5X Mini Set with M9N GPS₹41,839
Holybro Pix32 V5 Mini Baseboard: another version this guide coversHolybro Pix32 V5 Mini Baseboard₹2,629
Alternatives and when to choose them
- Pixhawk 6X and 6C: newer, faster.
- Pixhawk autopilots: ArduPilot basics.
- Pixhawk GPS modules: GPS choices.
Common mistakes to avoid
- Mounting the autopilot rotated without setting orientation.
- Skipping compass calibration away from metal.
- Wiring motors to the wrong outputs.
- Flying without failsafes set.
Frequently asked questions
Should I use PX4 or ArduPilot on a Pixhawk 5X?
Both work; PX4 suits research and ROS 2, ArduPilot has more vehicle types and features.
What is the difference between Pixhawk 4 and 5X?
The 5X has newer processors, isolated triple IMUs and digital power modules.
Why does the autopilot refuse to arm?
A pre-arm check fails; read the message in the ground station and fix it.
Which outputs drive the motors?
Follow the airframe layout; quads usually use MAIN 1 to 4 or FMU outputs.
Can I run it with ROS 2?
Yes, with PX4 and the micro XRCE-DDS bridge, or ArduPilot with DDS.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.




