Component guide · Intermediate · 4 min read
LTE-M, NB-IoT and Cat 1 Development Kits

Nordic nRF9151-DK, Particle Boron LTE CAT-M1, ST B-L462E-CELL1 Discovery Kit, SparkFun LTE Stick LARA-R6, Waveshare BG95-M3 EVB, AI-Thinker CA-01 Cat 1 bis and Seeed LinkIt ONE
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
LTE-M and NB-IoT are low-power cellular networks for battery IoT devices that send small amounts of data, such as meters and trackers. Cat 1 and Cat 1 bis give more speed with modest power. These kits pair a cellular modem with a microcontroller or USB so you can test coverage and build firmware. Check that your operator supports LTE-M or NB-IoT where you deploy before choosing.
Key specs at a glance
- Networks
- LTE-M and NB-IoT (nRF9151, BG95, Boron, B-L462E); Cat 1 (LARA-R6, CA-01)
- Extras
- GNSS on nRF9151 and BG95; DECT NR+ on nRF9151
- MCU
- nRF9151 built in; STM32L462 on B-L462E; nRF52840 on Boron
- SIM
- Nano SIM or eSIM/iSIM by kit
- Power
- Very low sleep current with PSM and eDRX
- Software
- nRF Connect SDK, Particle cloud, STM32Cube, AT commands
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1Nordic Semiconductor nRF9151-DK LTE-M/NB-IoT GNSS DECT NR+ DevKit₹13,919
Option 2Particle Boron LTE CAT-M1 IoT Development Board (BRN404X)₹6,799
Option 3STMicroelectronics B-L462E-CELL1 IoT Discovery Kit w/ LTE Cat M/NB & STM32L462RE₹9,189
Option 4SparkFun LTE Stick LARA-R6 LTE Cat 1 Module w/ Dual SMA₹13,749
Option 5Waveshare BG95 EVB Development Board w/ BG95-M3 LTE Cat M1/NB2 & GNSS₹6,119
Option 6AI-Thinker CA-01 LTE Cat.1 bis Module Dev Board₹2,312
What the LTE-M, NB-IoT and Cat 1 dev kits: nRF9151-DK, Particle Boron, B-L462E-CELL1, LARA-R6 LTE Stick, BG95 EVB, CA-01 and LinkIt ONE is
LTE-M and NB-IoT cellular dev kits, such as boards with the SIM7080G, BG95 or nRF9160, connect low-power IoT devices over mobile networks using little data and battery.
LTE-M and NB-IoT coverage depends on the operator and region, so test with a SIM from the network you will use. A normal phone SIM may not register on NB-IoT; an IoT SIM or the kit's bundled SIM is often needed.
Start with AT commands to see the modem register, then move to the vendor SDK for low-power sleep (PSM and eDRX), which is where battery life comes from. The LinkIt ONE is an older 2G board, useful only where 2G service still runs.
LTE-M, NB-IoT and Cat 1 dev kits: nRF9151-DK, Particle Boron, B-L462E-CELL1, LARA-R6 LTE Stick, BG95 EVB, CA-01 and LinkIt ONE pinout
The pins on the LTE-M, NB-IoT and Cat 1 dev kits: nRF9151-DK, Particle Boron, B-L462E-CELL1, LARA-R6 LTE Stick, BG95 EVB, CA-01 and LinkIt ONE and what each one does.
| Pin | Function |
|---|---|
| SIM / eSIM | Network identity |
| LTE antenna | u.FL or SMA |
| GNSS antenna | On kits with GPS |
| USB | Power, flashing and AT port |
| UART | AT interface to an external MCU |
| PWRKEY / RESET | Modem power control |
- SIM / eSIM
- Network identity
- LTE antenna
- u.FL or SMA
- GNSS antenna
- On kits with GPS
- USB
- Power, flashing and AT port
- UART
- AT interface to an external MCU
- PWRKEY / RESET
- Modem power control
Wiring the LTE-M, NB-IoT and Cat 1 dev kits: nRF9151-DK, Particle Boron, B-L462E-CELL1, LARA-R6 LTE Stick, BG95 EVB, CA-01 and LinkIt ONE
Cellular modems draw short current peaks; use a battery or supply that can deliver them, not a weak USB hub.
| LTE-M, NB-IoT and Cat 1 dev kits: nRF9151-DK, Particle Boron, B-L462E-CELL1, LARA-R6 LTE Stick, BG95 EVB, CA-01 and LinkIt ONE pin | Connection | Note |
|---|---|---|
| LTE antenna | Main port | Before power on |
| SIM | Slot | IoT SIM for NB-IoT |
| USB | PC | Serial monitor or SDK |
- LTE antenna
- Connection:
- Main port
- Note:
- Before power on
- SIM
- Connection:
- Slot
- Note:
- IoT SIM for NB-IoT
- USB
- Connection:
- PC
- Note:
- Serial monitor or SDK
Example code
Mode commands differ between modem makers; check the AT manual for your kit's modem.
AT -> OK
AT+CFUN=1 (radio on)
AT+CPIN? (SIM ready?)
AT+CEREG? (+CEREG: 0,1 or 0,5 means registered)
AT+COPS? (operator and access technology: 7 = LTE-M, 9 = NB-IoT)
AT+CESQ (signal)
nRF91 example, choose LTE-M and GNSS:
AT%XSYSTEMMODE=1,0,1,0
Quectel BG95 example, LTE-M first, then NB-IoT:
AT+QCFG="iotopmode",2
AT+QCFG="nwscanseq",0203Setup and tuning
confirm your operator and SIM support NB-IoT or LTE-M in your area; not all SIMs do.
feed a stable supply that handles transmit peaks; add a large capacitor.
start with AT, AT+CPIN? and AT+CSQ to check the SIM and signal.
set the bands your operator uses, such as band 3, 5 or 8.
use PSM and eDRX modes for long battery life.
What you need
Shop this list7 of 7 found in our store · ₹59,055
Nordic Semiconductor Semiconductor nRF9151-DK LTE-M/NB-IoT GNSS DECT NR+ DevKit: the part this guide coversNordic Semiconductor nRF9151-DK LTE-M/NB-IoT GNSS DECT NR+ DevKit₹13,919
Particle Boron LTE CAT-M1 IoT Development Board (BRN404X): another version this guide coversParticle Boron LTE CAT-M1 IoT Development Board (BRN404X)₹6,799
STMicroelectronics B-L462E-CELL1 IoT Discovery Kit w/ LTE Cat M/NB & STM32L462RE: another version this guide coversSTMicroelectronics B-L462E-CELL1 IoT Discovery Kit w/ LTE Cat M/NB & STM32L462RE₹9,189
SparkFun LTE Stick LARA-R6 LTE Cat 1 Module w/ Dual SMA: another version this guide coversSparkFun LTE Stick - LARA-R6₹13,680
Waveshare BG95 EVB Development Board w/ BG95-M3 LTE Cat M1/NB2 & GNSS: another version this guide coversWaveshare BG95 EVB Development Board w/ BG95-M3 LTE Cat M1/NB2 & GNSS₹6,119
AI-Thinker CA-01 LTE Cat.1 bis Module Dev Board: another version this guide coversAI-Thinker CA-01 LTE Cat.1 bis Module Dev Board₹2,312
Seeed Studio Studio LinkIt ONE IoT Dev Board (MT2502A, GSM, Wi-Fi, BLE, GPS): another version this guide coversSeeed Studio LinkIt ONE IoT Dev Board (MT2502A, GSM, Wi-Fi, BLE, GPS)₹7,037
Alternatives and when to choose them
- ESP32 cellular boards: ESP32 plus modem boards.
- 4G GPS modules: Cat 1 and Cat 4 modules.
- 5G M.2 modules: high-speed links.
Common mistakes to avoid
- Buying a module before checking operator support.
- Using a weak supply that resets on transmit.
- Leaving power-saving modes off.
- Sending large payloads often.
Frequently asked questions
What is the difference between NB-IoT and LTE-M?
NB-IoT is slower and uses less power; LTE-M is faster, supports moving devices and voice.
Will any SIM card work for NB-IoT?
No. The SIM and plan must support NB-IoT or LTE-M; check with your operator.
Why does the module not register on the network?
The band, APN or SIM plan is wrong, or there is no NB-IoT coverage.
How long can an NB-IoT device run on a battery?
Years, if it sends small messages rarely and uses PSM.
Can I send MQTT over NB-IoT?
Yes, though small payloads and MQTT-SN or UDP suit it best.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.
