Component guide · Beginner · 6 min read
Multirotor ESCs

SimonK 30A, EMAX SimonK and Lightning, DYS Quanum, ReadyToSky 30A to 80A, Hobbywing XRotor, T-Motor Air 40A, ZTW, SimpliFly and Flameback
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
These are the classic single ESCs for F450, S500 and other student quadcopters and hexacopters. The SimonK 30A is the most common starting point; Hobbywing XRotor and T-Motor Air are higher quality; and 40A to 80A ReadyToSky and Flameback ESCs suit bigger motors. Many include a BEC that powers the receiver or flight controller.
Key specs at a glance
- Current
- 12A to 80A continuous
- Voltage
- 2S to 6S LiPo
- Firmware
- SimonK, BLHeli or maker firmware
- Signal
- 50 to 490 Hz PWM, OneShot on some
- BEC
- 5V 1A to 3A on BEC versions; none on OPTO
- Connectors
- Bare, 3.5 mm bullet or banana
This part can carry many amps. Use wire thick enough for the current, put a fuse close to the battery, check that connectors are rated for the load and give drivers and motors room to cool. A short at these currents melts wires in seconds.
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1SimonK 30A Brushless ESC for Multicopter & RC Aircraft₹629
Option 2SimonK 30A BLDC ESC with 5V 2A BEC (2-3S LiPo)₹319
Option 3SimonK 30A BLDC ESC for 2-3S LiPo, No Connectors₹339
Option 4Standard 30A BLDC ESC 2-3S LiPo with 5V/3A BEC₹399
Option 5Simonk 30A ESC w/ 3.5mm Banana Connector (Female)₹709
Option 6ReadyToSky SimonK 12A Electronic Speed Controller with 5V 1A BEC₹319
What the Multirotor ESCs: SimonK, BLHeli and generic 20A to 80A is
Multirotor ESCs with SimonK or BLHeli firmware and a BEC drive brushless motors on beginner quadcopters and hexacopters, often 20 to 40 A, with PWM input.
For an F450 with 1000KV motors and 10 inch props on 3S, 30A ESCs are right. Use 40A for 4S and larger props.
Calibrate all ESCs to the same throttle range before the first flight, either through the flight controller's calibration or one by one with a receiver. With several BEC ESCs, connect only one red wire.
Multirotor ESCs: SimonK, BLHeli and generic 20A to 80A pinout
The pins on the Multirotor ESCs: SimonK, BLHeli and generic 20A to 80A and what each one does.
| Pin | Function |
|---|---|
| Battery leads | Red + and black - to the battery or PDB |
| Motor wires (3) | To the brushless motor in any order |
| Signal cable | White/yellow signal, black/brown ground, red BEC 5V |
| BEC | Built-in 5V or 6V supply for receiver and servos |
- Battery leads
- Red + and black - to the battery or PDB
- Motor wires (3)
- To the brushless motor in any order
- Signal cable
- White/yellow signal, black/brown ground, red BEC 5V
- BEC
- Built-in 5V or 6V supply for receiver and servos
Wiring the Multirotor ESCs: SimonK, BLHeli and generic 20A to 80A
Fit bullet connectors with heat-shrink so they cannot short. When several ESCs have BECs, remove the red wire from all but one signal plug.
| Multirotor ESCs: SimonK, BLHeli and generic 20A to 80A pin | Connection | Note |
|---|---|---|
| Battery | Battery or PDB | Check polarity twice |
| Signal | Receiver throttle channel or FC output | Signal plus GND |
| Motor | Three wires, any order | Swap two to reverse |
- Battery
- Connection:
- Battery or PDB
- Note:
- Check polarity twice
- Signal
- Connection:
- Receiver throttle channel or FC output
- Note:
- Signal plus GND
- Motor
- Connection:
- Three wires, any order
- Note:
- Swap two to reverse
Example code
On a Pixhawk use ArduPilot's all-at-once ESC calibration; on a KK2 or APM follow its calibration steps. Never calibrate with props on.
#include <Servo.h>
Servo esc;
void setup() {
Serial.begin(115200);
esc.attach(9, 1000, 2000);
// Calibration: full throttle at power-up, then low
esc.writeMicroseconds(2000);
Serial.println("Connect the battery now, wait for beeps");
delay(5000);
esc.writeMicroseconds(1000);
delay(4000); // ESC confirms range
}
void loop() {
for (int us = 1000; us <= 1300; us += 10) { esc.writeMicroseconds(us); delay(50); }
delay(2000);
esc.writeMicroseconds(1000);
delay(3000);
}Setup and tuning
choose an ESC rated above the motor's full-throttle current.
use only one ESC BEC to power the flight controller; remove the red wire on the others.
calibrate all ESCs together through the flight controller or one at a time.
swap two motor wires to reverse a motor.
mount on arms in the propwash for cooling.
What you need
Shop this list20 of 20 found in our store · ₹18,625
SimonK 30A Brushless ESC for Multicopter & RC Aircraft: the part this guide coversSimonK 30A Brushless ESC for Multicopter & RC Aircraft₹629
SimonK 30A BLDC ESC with 5V 2A BEC (2-3S LiPo): another version this guide coversSimonK 30A BLDC ESC with 5V 2A BEC (2-3S LiPo)₹319
SimonK 30A BLDC ESC for 2-3S LiPo, No Connectors: another version this guide coversSimonK 30A BLDC ESC for 2-3S LiPo, No Connectors₹339
Standard 30A BLDC ESC 2-3S LiPo with 5V/3A BEC: another version this guide coversStandard 30A BLDC ESC 2-3S LiPo with 5V/3A BEC₹399
Simonk 30A ESC w/ 3.5mm Banana Connector (Female): another version this guide coversSimonk 30A ESC w/ 3.5mm Banana Connector (Female)₹709
ReadyToSky SimonK 12A Electronic Speed Controller with 5V 1A BEC: another version this guide coversReadyToSky SimonK 12A Electronic Speed Controller with 5V 1A BEC₹319
EMAX SimonK Series 30A Brushless Multirotor ESC: another version this guide coversEMAX SimonK Series 30A Brushless Multirotor ESC₹1,769
EMAX SimonK 12A 2-4S Multirotor Brushless ESC: another version this guide coversEMAX SimonK 12A 2-4S Multirotor Brushless ESC₹529
EMAX Simon K Series 60A Brushless ESC: another version this guide coversEMAX Simon K Series 60A Brushless ESC₹1,774
EMAX Simon Series 20A ESC (2-4S) for Multirotor: another version this guide coversEMAX Simon Series 20A ESC (2-4S) for Multirotor₹859
EMAX Lightning 30A Brushless ESC 2-4S: another version this guide coversEMAX Lightning 30A Brushless ESC 2-4S₹1,609
DYS SimonK 30A Brushless ESC for Quadcopter: another version this guide coversDYS SimonK 30A Brushless ESC for Quadcopter₹930
DYS Quanum 20A Multi-copter Brushless ESC (OPTO) 2-4S: another version this guide coversDYS Quanum 20A Multi-copter Brushless ESC (OPTO) 2-4S₹829
DYS Quanum 30A Brushless ESC w/ 5V/2A BEC 2-4S LiPo: another version this guide coversDYS Quanum 30A Brushless ESC w/ 5V/2A BEC 2-4S LiPo₹789
DYS Quanum 30A Multi-Copter Brushless ESC w/ 5V/3A BEC: another version this guide coversDYS Quanum 30A Multi-Copter Brushless ESC w/ 5V/3A BEC₹1,089
DYS Quanum 40A Brushless ESC 2-4S w/ 5V/3A BEC: another version this guide coversDYS Quanum 40A Brushless ESC 2-4S w/ 5V/3A BEC₹1,899
Quanum 20A Multi-copter Brushless Speed Controller: another version this guide coversQuanum 20A Multi-copter Brushless Speed Controller₹751
Brushless 40A 2-4S ESC for Multirotor Drones: another version this guide coversBrushless 40A 2-4S ESC for Multirotor Drones₹1,099
ReadyToSky 2-6S 40A Opto Brushless ESC: another version this guide coversReadyToSky 2-6S 40A Opto Brushless ESC₹1,066
ReadyToSky 30A 2-6S Brushless ESC w/ Banana Connector: another version this guide coversReadyToSky 30A 2-6S Brushless ESC w/ Banana Connector₹919
Alternatives and when to choose them
- Single FPV ESCs: lighter, DShot.
- Heavy-lift ESCs: agriculture and cargo drones.
- UBEC regulators: separate 5V supply.
Common mistakes to avoid
- Leaving all red BEC wires connected.
- Skipping calibration.
- Under-rated ESCs.
- Mounting where no air flows.
Frequently asked questions
Why remove the red wire from extra ESCs?
So several BECs do not fight each other on the power rail.
How do I calibrate the ESCs?
Use the flight controller calibration or do each ESC with full then zero throttle.
What is SimonK?
An older open firmware for multirotor ESCs, replaced now by BLHeli and Bluejay.
Why does one motor start late?
That ESC was not calibrated with the others; calibrate all of them together.
How do I reverse a motor?
Swap any two of the three motor wires, or reverse it in BLHeli if supported.
Parts for this guide
- ₹629View
- ₹319View
- ₹339View
- ₹399View
- ₹709View
- ₹319View
- ₹1,769View
- ₹529View
- ₹1,774View
- ₹859View
- ₹1,609View
- ₹930View
- ₹829View
- ₹789View
- ₹1,089View
- ₹1,899View
- ₹751View
- ₹1,099View
- ₹1,066View
- ₹919View
- ₹819View
- ₹1,039View
- ₹1,079View
- ₹939View
- ₹2,139View
- ₹940View
- ₹2,614View
- ₹1,379View
- ₹2,659View
- ₹1,569View
- ₹3,289View
- ₹3,899View
- ₹18,349View
- ₹999View
- ₹100View
- ₹979View
- ₹359View
- ₹1,392View
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.


















