Component guide · Intermediate · 3 min read
Peltier Modules (TEC1-12706)
Cooling and Heating with Electricity
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
A Peltier module pumps heat from one ceramic face to the other when DC current flows, so one side gets cold and the other hot. The common TEC1-12706 is rated 12 V and up to about 6 A. The hot side must be bolted to a large heatsink and fan, or the module overheats in seconds. It is simple and silent but inefficient: it usually uses more power than the heat it moves.
Key specs at a glance
- Model
- TEC1-12706: 40 × 40 mm
- Rating
- 12 V nominal, about 6 A maximum
- Max heat pumped
- About 50 to 60 W at zero temperature difference
- Max temperature difference
- About 65 °C with no heat load
- Efficiency (COP)
- Usually below 1 in real use
- Reversing current
- Swaps hot and cold sides
How it works
Inside are many small pairs of semiconductor blocks between two ceramic plates. Current carries heat from one plate to the other. The hot side must get rid of both the heat pumped and the electrical power used: at 12 V and 5 A the module itself adds 60 W, so the hot-side heatsink handles 60 W plus whatever it moves. That is why a CPU-style heatsink with fan, or a water block, is essential.
Building a small cooler
- 1Clamp the module between a large heatsink and fan (hot side) and a smaller cold plate or heatsink (cold side), with thin thermal paste on both faces.
- 2Use a 12 V supply rated at least 6 A per module; an SMPS is ideal.
- 3Insulate the cold side so it is not fighting the room air.
- 4Control temperature with a temperature controller or a microcontroller switching a MOSFET or relay on and off slowly. Very fast PWM wastes power; smooth DC current is more efficient.
Expect condensation on the cold side in humid weather; protect electronics nearby.
Protect the module
Never power it without a heatsink, even for a few seconds. Do not exceed the rated voltage. Mount with even clamping pressure so the ceramic does not crack. If the hot side heatsink is too small, the cold side warms up too and cooling stops working.
Try it: Power supply sizing calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Powering without a heatsink.
- An undersized hot-side heatsink.
- Expecting refrigerator efficiency.
- Uneven clamping that cracks the ceramic.
- Ignoring condensation.
Frequently asked questions
How cold can a Peltier module get?
In practice 10 to 30 °C below room temperature with a good heatsink and a small, insulated load.
What power supply does a TEC1-12706 need?
12 V at about 6 A. Use a supply rated higher than that.
Can I control a Peltier with Arduino?
Yes, through a high-current MOSFET or relay, switching slowly, or with an H-bridge to heat or cool.
Can a Peltier generate electricity?
Yes, with a temperature difference across it, but only a small amount of power.
Why is the cold side not getting cold?
The hot side is not being cooled enough. Use a bigger heatsink and fan.
Parts for this guide
Calculators
Terms in this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.


