Comparison · Intermediate · 3 min read
RC Transmitters and Receivers
ELRS, FlySky and Protocols
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
An RC transmitter sends stick positions to a receiver in the model. FlySky radios such as the FS-i6X are affordable and simple, while ExpressLRS (ELRS) is an open-source link with long range and low latency used by most FPV pilots today. The receiver passes channels to a flight controller as a serial stream such as CRSF, SBUS or iBUS, or to servos as PWM. Always set and test failsafe before flying.
Key specs at a glance
- FlySky AFHDS 2A
- Budget radios like FS-i6X; iBUS and PPM output
- ExpressLRS
- Open-source, 2.4 GHz or 900 MHz, long range, high packet rates, CRSF output
- FrSky ACCST / ACCESS
- SBUS output, telemetry
- TBS Crossfire
- 900 MHz long range, CRSF
- Receiver outputs
- PWM (one wire per channel), PPM, iBUS, SBUS, CRSF
- Radio firmware
- EdgeTX and OpenTX on many multi-protocol radios
Protocols compared
| System | Band | Range | Output | Typical use |
|---|---|---|---|---|
| FlySky AFHDS 2A | 2.4 GHz | Short to medium | PWM, PPM, iBUS | Planes, cars, first drones |
| ExpressLRS 2.4 | 2.4 GHz | Long | CRSF | FPV drones of all sizes |
| ExpressLRS 900 | 868/915 MHz | Very long | CRSF | Long-range planes and drones |
| FrSky ACCST/ACCESS | 2.4 GHz | Medium | SBUS | Drones, planes with telemetry |
| TBS Crossfire | 868/915 MHz | Very long | CRSF | Long range |
- FlySky AFHDS 2A
- Band:
- 2.4 GHz
- Range:
- Short to medium
- Output:
- PWM, PPM, iBUS
- Typical use:
- Planes, cars, first drones
- ExpressLRS 2.4
- Band:
- 2.4 GHz
- Range:
- Long
- Output:
- CRSF
- Typical use:
- FPV drones of all sizes
- ExpressLRS 900
- Band:
- 868/915 MHz
- Range:
- Very long
- Output:
- CRSF
- Typical use:
- Long-range planes and drones
- FrSky ACCST/ACCESS
- Band:
- 2.4 GHz
- Range:
- Medium
- Output:
- SBUS
- Typical use:
- Drones, planes with telemetry
- TBS Crossfire
- Band:
- 868/915 MHz
- Range:
- Very long
- Output:
- CRSF
- Typical use:
- Long range
Receiver outputs explained
one signal wire per channel, as a servo pulse of about 1000 to 2000 µs. Used with planes, cars and Arduino projects (read with pulseIn()).
all channels on one wire in sequence. Older but simple.
digital serial streams on one UART. Flight controllers prefer these. CRSF also carries telemetry back to the radio.
In Betaflight, set the receiver type on the Receiver tab and assign the UART on the Ports tab; see flight controllers.
Binding, modes and failsafe
Bind the receiver to the transmitter by the method in its manual (bind button, or a bind phrase for ELRS). Mode 2, with throttle and yaw on the left stick, is the most common worldwide; Mode 1 puts throttle on the right.
Failsafe decides what the model does when signal is lost: drones should disarm or drop throttle, planes might circle or glide. Test it with props off by switching off the transmitter. Calibrate stick endpoints so each channel reaches about 1000 and 2000 µs, and update ELRS transmitter and receiver to the same major firmware version.
Try it: PWM duty cycle calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Flying without testing failsafe.
- Mismatched ELRS firmware versions or bind phrases.
- Choosing SBUS on a UART that cannot invert the signal.
- Mixing up Mode 1 and Mode 2 sticks.
- Placing receiver antennas against carbon fibre or wires.
Frequently asked questions
Is the FlySky FS-i6X good for beginners?
Yes, it is affordable and reliable for planes, cars and first drones. Many FPV pilots later move to an ELRS radio.
What is ExpressLRS?
An open-source radio control link with long range, low latency and high update rates, now the most common choice for FPV.
What is the difference between SBUS and iBUS?
Both carry many channels on one serial wire. SBUS is FrSky's inverted protocol; iBUS is FlySky's.
Can Arduino read an RC receiver?
Yes. Read PWM channels with pulseIn(), or decode iBUS, SBUS or CRSF on a serial port with a library.
What should failsafe do on a drone?
Disarm or cut throttle so it drops rather than flies away. Test it with propellers removed.
Parts for this guide
Calculators
Terms in this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.



