Shop by category
Shop all components3D printing
New E-steps = old E-steps × requested length ÷ actual lengthCurrent value 93 steps/mm. You ask for 100 mm and measure 97 mm extruded: new = 93 × 100 ÷ 97 = 95.88 steps/mm.
Extruder calibration makes sure the printer pushes out exactly as much filament as the slicer expects. Under-extrusion causes gaps and weak parts; over-extrusion causes blobs and poor dimensional accuracy.
Heat the nozzle to printing temperature, remove the nozzle or extrude in free air, and measure the filament that moved. Repeat once after setting the new value. Tune flow rate in the slicer afterwards for the fine adjustments.
Mark 120 mm of filament, extrude 100 mm, measure what moved, then new = old × 100 ÷ actual.
Send M92 E<value> and M500 in Marlin, or set it in the printer menu.
Yes, at printing temperature, extruding slowly so pressure does not affect the result.
New E-steps = old E-steps × requested length ÷ actual length.
Current value 93 steps/mm. You ask for 100 mm and measure 97 mm extruded: new = 93 × 100 ÷ 97 = 95.88 steps/mm.
Geekobot builds that use it include Seed germination chamber heater, Bread dough proofing box, Wi-Fi curd incubator and Wi-Fi seed germination chamber. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators