Shop by category
Shop all components3D printing
This ignores the rising heat loss as the part gets hotter, so real heat-up takes somewhat longer, especially near the target.
Energy Q = mass × specific heat × ΔTTime = Q ÷ (power × efficiency)Power needed = Q ÷ (time × efficiency)A 392 g aluminium bed heated from 25 °C to 60 °C: Q = 392 × 0.9 × 35 = 12,348 J. A 240 W heater with 70% efficiency (168 W) takes about 74 s; doing it in 90 s needs 196 W.
Heating something takes a fixed amount of energy that depends only on its mass, material and temperature rise. The heater’s power then determines how fast that energy arrives.
Use it to size a heated bed, a hot end block or a heater for an enclosure. Aluminium heats fastest per watt because of its low mass, and a good insulation layer under the bed saves a lot of power.
Time = mass × 4186 × ΔT ÷ (power × efficiency). 1 L from 25 to 100 °C with a 1000 W heater takes about 5.5 minutes.
The energy to raise 1 kg by 1 °C: 4186 J for water, about 900 J for aluminium.
Heat escapes to the air and container. Lower the efficiency in the calculator for open or uninsulated setups.
Energy Q = mass × specific heat × ΔT; Time = Q ÷ (power × efficiency); Power needed = Q ÷ (time × efficiency).
A 392 g aluminium bed heated from 25 °C to 60 °C: Q = 392 × 0.9 × 35 = 12,348 J. A 240 W heater with 70% efficiency (168 W) takes about 74 s; doing it in 90 s needs 196 W.
Geekobot builds that use it include Seed germination chamber heater, Bread dough proofing box, Wi-Fi curd incubator and Wi-Fi seed germination chamber. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators