Shop by category
Shop all components3D printing
Flow (mm³/s) = line width × layer height × speedFilament feed = flow ÷ (π ÷ 4 × d²)Max speed = flow limit ÷ (width × height)0.4 mm lines at 0.2 mm layers and 60 mm/s: 4.8 mm³/s, which needs 2.0 mm/s of 1.75 mm filament. A standard 11 mm³/s hot end can go up to 137 mm/s at this size.
The real speed limit of a 3D printer is often not the motors but the hot end: it can only melt a certain volume of plastic every second. Fast prints with thick lines or layers hit this limit first.
To find your limit, extrude filament at increasing speeds and note where it starts to click or the extrusion shrinks. Use that as the maximum volumetric speed in your slicer, and the speeds will adjust automatically.
Plastic volume per second: line width × layer height × speed. 0.45 × 0.2 × 100 mm/s = 9 mm³/s.
Roughly 10 to 15 mm³/s for a typical V6-style hotend with PLA. High-flow hotends reach 25 mm³/s or more.
The plastic cannot melt fast enough, causing under-extrusion and weak layers.
Flow (mm³/s) = line width × layer height × speed; Filament feed = flow ÷ (π ÷ 4 × d²); Max speed = flow limit ÷ (width × height).
0.4 mm lines at 0.2 mm layers and 60 mm/s: 4.8 mm³/s, which needs 2.0 mm/s of 1.75 mm filament. A standard 11 mm³/s hot end can go up to 137 mm/s at this size.
Geekobot builds that use it include Seed germination chamber heater, Bread dough proofing box, Wi-Fi curd incubator and Wi-Fi seed germination chamber. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators