Shop by category
Shop all componentsTiming, filters & signals
fc = 1 ÷ (2π × R × C)Low-pass gain = 1 ÷ √(1 + (f/fc)²)High-pass gain = (f/fc) ÷ √(1 + (f/fc)²)1 kΩ and 100 nF: fc = 1 ÷ (2π × 1000 × 0.0000001) = 1.59 kHz. At 10 kHz a low-pass passes 0.157 of the signal (−16.1 dB).
A single resistor and capacitor make a first-order filter. As a low-pass, it lets slow signals through and smooths fast noise, which is how you clean up a sensor reading or turn PWM into a steady voltage. As a high-pass, it blocks DC and passes changes, for example to couple audio between stages.
At the cutoff frequency the output is 70.7% of the input (−3 dB), and it falls by ten times for every ten-times increase in frequency beyond. For a steeper response, cascade stages or use an active op-amp filter.
fc = 1 ÷ (2π × R × C). At that frequency the output is about 70.7 % (−3 dB) of the input.
A low-pass filter (R in series, C to ground) keeps slow signals and removes fast noise. A high-pass filter (C in series, R to ground) blocks DC and passes fast changes.
Use an RC low-pass with a cutoff well below the PWM frequency, for example 10 kΩ and 10 µF (about 1.6 Hz) for 490 Hz Arduino PWM.
fc = 1 ÷ (2π × R × C); Low-pass gain = 1 ÷ √(1 + (f/fc)²); High-pass gain = (f/fc) ÷ √(1 + (f/fc)²).
1 kΩ and 100 nF: fc = 1 ÷ (2π × 1000 × 0.0000001) = 1.59 kHz. At 10 kHz a low-pass passes 0.157 of the signal (−16.1 dB).
Geekobot builds that use it include Dark detector with an LM358 comparator and LM358 comparator with two knobs. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators