Shop by category
Shop all componentsTiming, filters & signals
τ = R × CCharging: V(t) = Vs × (1 − e^(−t/τ))Discharging: V(t) = V0 × e^(−t/τ)Time to x%: t = −τ × ln(1 − x)10 kΩ and 100 µF: τ = 10,000 × 0.0001 = 1 s. After 1 s the capacitor is at 63.2% of the supply, and it is practically full after 5 s.
When a capacitor charges through a resistor, the voltage rises quickly at first and then slows down. The time constant τ (tau) is the time to reach 63.2% of the final voltage; after five time constants it is over 99% charged.
RC circuits set power-on reset delays, debounce push buttons, smooth PWM into an analogue voltage and set the frequency of timers. Real electrolytic capacitors can be 20% off their marked value, so allow some margin in timing circuits.
τ = R × C. After one time constant a charging capacitor reaches about 63 % of the supply voltage.
About five time constants (5 × R × C) brings it to over 99 % of the supply.
10,000 × 0.0001 = 1 second, so it reaches 63 % in 1 s and is nearly full after 5 s.
τ = R × C; Charging: V(t) = Vs × (1 − e^(−t/τ)); Discharging: V(t) = V0 × e^(−t/τ); Time to x%: t = −τ × ln(1 − x).
10 kΩ and 100 µF: τ = 10,000 × 0.0001 = 1 s. After 1 s the capacitor is at 63.2% of the supply, and it is practically full after 5 s.
Geekobot builds that use it include 555 timer LED flasher, Two-transistor LED flasher (astable multivibrator), Dust sensor air monitor and Dust level colour ring. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators