Shop by category
Shop all componentsTiming, filters & signals
Duty cycle is always above 50% in this circuit; add a diode across R2 for less.
t high = 0.693 × (R1 + R2) × Ct low = 0.693 × R2 × Cf = 1.44 ÷ ((R1 + 2 × R2) × C)Duty = (R1 + R2) ÷ (R1 + 2 × R2)R1 = 1 kΩ, R2 = 10 kΩ, C = 10 µF: t high = 0.693 × 11,000 × 0.00001 = 76 ms, t low = 69 ms, f ≈ 6.9 Hz, duty 52%. A nice LED blink rate.
In astable mode the 555 timer runs as a free-running oscillator: the capacitor charges through R1 and R2 to two-thirds of the supply, then discharges through R2 to one-third, again and again. The output on pin 3 is a square wave.
It is the classic first IC project for blinking LEDs, beeping buzzers and generating clock pulses. Use a film or ceramic capacitor for stable timing at higher frequencies; electrolytics are fine for slow blinkers. The CMOS version (TLC555, 7555) uses far less current.
The capacitor charges through R1 + R2 but discharges only through R2, so high is always longer. Make R2 much larger than R1, or add a diode across R2.
f = 1.44 ÷ ((R1 + 2 × R2) × C). With R1 = 1 kΩ, R2 = 10 kΩ and 10 µF it blinks at about 6.9 Hz.
Yes. R1 = 10 kΩ, R2 = 68 kΩ and C = 10 µF give about 1 Hz.
t high = 0.693 × (R1 + R2) × C; t low = 0.693 × R2 × C; f = 1.44 ÷ ((R1 + 2 × R2) × C); Duty = (R1 + R2) ÷ (R1 + 2 × R2).
R1 = 1 kΩ, R2 = 10 kΩ, C = 10 µF: t high = 0.693 × 11,000 × 0.00001 = 76 ms, t low = 69 ms, f ≈ 6.9 Hz, duty 52%. A nice LED blink rate.
Geekobot builds that use it include 555 timer LED flasher, 555 continuity tester that beeps, Push-button timed light with a 555 and 555 tone generator with a pitch knob. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators