555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsIn one-shot mode the 555 switches its output on when pin 2 is pulled low, and keeps it on until the capacitor charges to ⅔ of the supply. 100 kΩ and 100 µF give about 11 seconds (t = 1.1 × R × C), perfect for a stair or cupboard light.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
8 parts: NE555 Timer IC (DIP-8), Tactile Push Button Switch, Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Electrolytic Capacitor, Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 30 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹177 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
The 555 timer in monostable mode; One-shot delays set by R and C.
Ideas that reuse this build: LED flasher. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
An LED that switches on by itself at dusk, using a chip instead of code.
Learning project. Check every circuit and the datasheet of each part before you power it up.