555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsYour skin conducts a tiny current, far too small to light an LED. Two transistors in a Darlington pair multiply it about 40,000 times, enough to switch the LED fully on. A great demonstration of current gain.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
6 parts: General Purpose Transistors (Pack), Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 30 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹158 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Transistors as switches; Current gain and skin resistance.
Ideas that reuse this build: Capacitive touch lamp with Arduino. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
An LED that switches on by itself at dusk, using a chip instead of code.
Learning project. Check every circuit and the datasheet of each part before you power it up.