Push-button timed light with a 555
Press once and the light stays on for about 11 seconds, then goes off by itself.
Shop by category
Shop all componentsNo code, no microcontroller: two resistors and a capacitor set how fast the 555 charges and discharges, and its output flips each time. With 10 kΩ, 47 kΩ and 10 µF it blinks at about 1.4 Hz. Swap the capacitor to change the speed.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
7 parts: NE555 Timer IC (DIP-8), Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Electrolytic Capacitor, Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 30 minutes. The build on this page has 6 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹170 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
The 555 timer in astable mode; RC timing: how R and C set the blink rate.
Ideas that reuse this build: LED chaser with a CD4017 and Timed light with a push button. They are listed under Take it further on this page.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
An LED that switches on by itself at dusk, using a chip instead of code.
Learning project. Check every circuit and the datasheet of each part before you power it up.