555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsThe 555 is wired to make a tone, but its reset pin 4 is held low by a 1 kΩ resistor, so it stays silent. One probe goes to the supply and the other to pin 4. When the probes touch a good wire, fuse, switch contact or PCB track, pin 4 is pulled high and the speaker beeps. A broken wire or blown fuse stays silent. It is a handy workshop tool you can build in half an hour.
Only test circuits that are switched off and unplugged. Never touch the probes to mains wiring.
Tick anything you already have and the total updates.
Two long leads with crocodile clips as probes; Connects the parts
Follow the colours: red is power, dark grey is ground, blue is a signal.
7 parts: NE555 Timer IC (DIP-8), Ceramic Disc Capacitor, Piezo Buzzer (passive), Resistor Assortment Kit (30 Values), Dupont Jumper Wires (40 pcs), Battery Holder (AA) and Solderless Breadboard (830 points). Tools: Digital Multimeter and Wire Stripper and Cutter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 45 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹170 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Only test circuits that are switched off and unplugged. Never touch the probes to mains wiring.
Ideas that reuse this build: 555 tone generator and Battery voltage tester. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.