Component guide · Intermediate · 5 min read
F4 Flight Controllers

SpeedyBee F405 V3 and Mini, Holybro Kakute F4, Matek F405-OSD, HGLRC Specter F405, iFlight BLITZ Mini F4, Zerodrag Nova, DarkMatter BRAHMA F4, Flywoo GOKU and Omnibus F4
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
F4 flight controllers use the STM32F405 chip and are the standard choice for Betaflight and iNav FPV quads. They have an OSD chip for analog video, enough UARTs for a receiver, GPS and VTX, and blackbox logging. SpeedyBee boards add Bluetooth for phone set-up; DarkMatter BRAHMA and Zerodrag Nova are made in India; Flywoo GOKU 16x16 boards fit small whoops and toothpicks.
Key specs at a glance
- Processor
- STM32F405, 168 MHz
- Gyro
- MPU6000, ICM42688P or BMI270
- Mounting
- 16x16, 20x20 or 30.5x30.5 mm
- OSD
- AT7456E analog OSD
- UARTs
- 4 to 6
- Firmware
- Betaflight, iNav, some ArduPilot
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1SpeedyBee F405 V3 30×30 Flight Controller₹4,130
Option 2SpeedyBee F405 Mini 20×20 Flight Controller₹5,679
Option 3Holybro Kakute F4 Flight Controller₹2,059
Option 4Holybro Kakute F4 V2.4 Flight Controller₹5,009
Option 5Matek Systems F405-OSD Flight Controller – BetaFlight OSD, 168MHz STM32F405, ICM-20602 Gyro₹2,499
Option 6HGLRC Specter F405 Flight Controller₹4,129
What the Betaflight F4 (F405) flight controllers is
F4 flight controllers use an STM32F405 or F411 chip to run Betaflight or INAV, reading the gyro and driving the ESCs for FPV quads and small drones.
F4 boards are plenty for 5 inch freestyle and racing with an 8 kHz gyro loop. Choose by size, UART count, and whether you need a barometer (for iNav and GPS work) or Bluetooth.
Old Omnibus F4 boards are still useful for learning but use older gyros; for a new build pick a current board.
Betaflight F4 (F405) flight controllers pinout
The pins on the Betaflight F4 (F405) flight controllers and what each one does.
| Pin | Function |
|---|---|
| ESC connector (8-pin) | Battery voltage, current, telemetry and motor signals from a 4-in-1 ESC |
| UARTs (T1/R1 ...) | Receiver (CRSF/SBUS), GPS, VTX control and telemetry |
| 5V / 9V / 10V pads | BEC outputs for receiver, camera and VTX |
| CAM / VTX pads | Analog video in and out through the OSD |
| Boot button and USB | Flashing firmware and configuration |
- ESC connector (8-pin)
- Battery voltage, current, telemetry and motor signals from a 4-in-1 ESC
- UARTs (T1/R1 ...)
- Receiver (CRSF/SBUS), GPS, VTX control and telemetry
- 5V / 9V / 10V pads
- BEC outputs for receiver, camera and VTX
- CAM / VTX pads
- Analog video in and out through the OSD
- Boot button and USB
- Flashing firmware and configuration
Wiring the Betaflight F4 (F405) flight controllers
Receiver TX goes to FC RX and receiver RX to FC TX. Always fit the VTX antenna before plugging in a battery, and use a smoke stopper for the first power-up.
| Betaflight F4 (F405) flight controllers pin | Connection | Note |
|---|---|---|
| 4-in-1 ESC | 8-pin harness | Check pin order |
| ELRS receiver | UART TX/RX crossed, 5V, GND | Serial RX = CRSF |
| VTX | 9V/10V, video out, UART for SmartAudio | Antenna on before power |
| GPS | Spare UART, 5V | For GPS rescue |
- 4-in-1 ESC
- Connection:
- 8-pin harness
- Note:
- Check pin order
- ELRS receiver
- Connection:
- UART TX/RX crossed, 5V, GND
- Note:
- Serial RX = CRSF
- VTX
- Connection:
- 9V/10V, video out, UART for SmartAudio
- Note:
- Antenna on before power
- GPS
- Connection:
- Spare UART, 5V
- Note:
- For GPS rescue
Example code
Use the 'Presets' tab for good starting tunes. iNav and ArduPilot run on many of these boards too; check the target list.
1. Flash the right target in Betaflight Configurator (Firmware Flasher)
2. Ports tab: Serial RX on the receiver UART; GPS / VTX on their UARTs
3. Configuration: board orientation, ESC protocol DSHOT600, bidir DShot ON
4. Receiver tab: CRSF, check sticks move the right channels
5. Motors tab (props OFF): motor order and direction match the diagram
6. Modes: ARM on a switch, ANGLE / HORIZON, BEEPER, GPS RESCUE
7. OSD: battery voltage, RSSI/LQ, flight time
8. CLI: save, then a hover test outdoorsSetup and tuning
use the exact Betaflight target for your board, found on the box or the maker's page.
assign the receiver UART, then set the receiver type (CRSF, SBUS) in the Receiver tab.
check them in the Motors tab with props off before the first flight.
mount on rubber grommets so frame vibration does not reach the gyro.
calibrate the battery voltage and current sensor so the OSD and alarms are right.
What you need
Shop this list20 of 20 found in our store · ₹73,212
SpeedyBee F405 V3 30×30 Flight Controller: the part this guide coversSpeedyBee F405 V3 30×30 Flight Controller₹4,130
SpeedyBee F405 Mini 20×20 Flight Controller: another version this guide coversSpeedyBee F405 Mini 20×20 Flight Controller₹5,679
Holybro Kakute F4 Flight Controller: another version this guide coversHolybro Kakute F4 Flight Controller₹2,059
Holybro Kakute F4 V2.4 Flight Controller: another version this guide coversHolybro Kakute F4 V2.4 Flight Controller₹5,009
Matek Systems F405-OSD Flight Controller – BetaFlight OSD, 168MHz STM32F405, ICM-20602 Gyro: another version this guide coversMatek Systems F405-OSD Flight Controller – BetaFlight OSD, 168MHz STM32F405, ICM-20602 Gyro₹2,499
HGLRC Specter F405 Flight Controller: another version this guide coversHGLRC Specter F405 Flight Controller₹4,129
iFlight BLITZ Mini F4 Flight Controller – 20x20mm, 2S-6S: another version this guide coversiFlight BLITZ Mini F4 Flight Controller – 20x20mm, 2S-6S₹2,539
Zerodrag Nova F4 Flight Controller: another version this guide coversZerodrag Nova F4 Flight Controller₹5,269
DarkMatter BRAHMA F4 MK-III STM32F405 Flight Controller Made In India: another version this guide coversDarkMatter BRAHMA F4 MK-III STM32F405 Flight Controller Made In India₹4,609
EDITHFPV Ironcore F4 Flight Controller – 30.5×30.5mm: another version this guide coversEDITHFPV Ironcore F4 Flight Controller – 30.5×30.5mm₹3,899
BotWing F405 Flight Controller (Fully Solderless Design): another version this guide coversBotWing F405 Flight Controller (Fully Solderless Design)₹4,699
Flywoo GOKU F405 Nano FC 16×16 ICM42688 Gyro: another version this guide coversFlywoo GOKU F405 Nano FC 16×16 ICM42688 Gyro₹4,239
Flywoo GOKU CubePilot GN405 Nano FC w/ ICM42688 (16x16mm): another version this guide coversFlywoo GOKU CubePilot GN405 Nano FC w/ ICM42688 (16x16mm)₹4,119
Mamba F4 Pro V2 Flight Controller: another version this guide coversMamba F4 Pro V2 Flight Controller₹2,950
Mamba F405 Flight Controller Betaflight STM32: another version this guide coversMamba F405 Flight Controller Betaflight STM32₹1,989
F4 V3S Plus Flight Control OSD 2-6S Two-way 3A BEC 9V Pad Design for Betaflight FPV Racing Drone: another version this guide coversF4 V3S Plus Flight Control OSD 2-6S Two-way 3A BEC 9V Pad Design for Betaflight FPV Racing Drone₹4,009
OMNIBUS F4 Flight Controller with OSD + BEC: another version this guide coversOMNIBUS F4 Flight Controller with OSD + BEC₹3,237
OMNIBUS F4 Pro V3 Flight Controller: another version this guide coversOMNIBUS F4 Pro V3 Flight Controller₹2,990
OMNIBUS F4 V2 PRO Flight Controller with SD Card Slot & BEC: another version this guide coversOMNIBUS F4 V2 PRO Flight Controller with SD Card Slot & BEC₹3,169
Omnibus F4 V2 PRO Flight Controller with Built-in OSD: another version this guide coversOmnibus F4 V2 PRO Flight Controller with Built-in OSD₹1,990
Alternatives and when to choose them
- F7 and H7 flight controllers: more UARTs, faster.
- FC and ESC stacks: matched pairs.
- ELRS receivers: radio link.
Common mistakes to avoid
- Flashing a firmware target for a different board.
- Testing motors with props on.
- Hard-mounting the board so the gyro picks up vibration.
- Leaving the current sensor uncalibrated, so mAh used is wrong.
Frequently asked questions
Is an F4 flight controller good enough?
Yes. F405 boards handle Betaflight freestyle and INAV well; F7 and H7 add more UARTs and headroom.
What is the difference between F405 and F411?
The F411 is cheaper with fewer UARTs; the F405 has more ports for GPS, VTX control and receivers.
Why does my receiver not show in Betaflight?
Check the UART assignment in Ports, the receiver protocol, and TX and RX wiring.
Can an F4 board run INAV for GPS flights?
Many F405 boards support INAV; check that your board has an INAV target.
Do I need a separate OSD?
No. Most F4 boards have an OSD chip built in for analog video.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.





