Component guide · Intermediate · 4 min read
Fixed-Wing Flight Controllers and Gyros

SpeedyBee F405 Wing Mini, Kakute H743 Wing with M10 GPS, iFlight BLITZ Wing H743, RadioLink Byme-A, Byme-D and Byme-DB, NX3 Pro, NX4 EVO and FMS Reflex V2
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
These boards stabilise RC planes and flying wings. Wing flight controllers (SpeedyBee F405 Wing Mini, Kakute H743 Wing, BLITZ Wing H743) run iNav or ArduPilot Plane for GPS return-to-home, waypoints and an OSD, with built-in PDBs and servo rails. Simple gyros (RadioLink Byme, NX3 Pro, NX4 EVO, FMS Reflex) sit between the receiver and servos to steady the plane and help beginners.
Key specs at a glance
- Wing FCs
- STM32F405 or H743, iNav or ArduPilot
- Power
- Built-in PDB and 5V/6V/9V BECs on wing boards
- Servo outputs
- 6 to 12
- Gyros
- 3-axis stabilisation, self-level, 3D modes
- Sensors
- Barometer, airspeed port, GPS
- Planes
- Trainers, flying wings, FPV long-range
Models in this guide
These are alternatives. Pick the one that fits your project; you only need one.
Option 1SpeedyBee F405 WING MINI Fixed Wing Flight Controller₹3,773
Option 2Holybro Kakute H743 Wing Flight Controller with Micro M10 GPS Module₹14,984
Option 3iFlight BLITZ Wing H743 Flight Controller₹10,429
Option 4RadioLink Byme-DB Mini Fixed Wing Flight Controller₹1,599
Option 5RadioLink Byme-A Flight Controller₹1,899
Option 6RadioLink Byme-D Flight Controller₹939
What the Fixed-wing flight controllers and RC plane gyros is
Fixed-wing flight controllers and gyros stabilise RC planes, from simple 3-axis gyro receivers to full controllers running INAV or ArduPilot with GPS return to home.
For FPV and autonomous flying, use a wing FC with GPS: iNav is quick to set up for return-to-home, while ArduPilot Plane offers full mission planning.
For a first trainer, a simple gyro such as the Byme-A or NX3 Pro gives stabilised and self-level modes without any computer set-up beyond switches.
Fixed-wing flight controllers and RC plane gyros pinout
The pins on the Fixed-wing flight controllers and RC plane gyros and what each one does.
| Pin | Function |
|---|---|
| Servo rail | Signal and BEC power for control surfaces |
| Motor output | ESC signal |
| Receiver port | CRSF, SBUS or PPM |
| GPS / airspeed | UART and I2C |
| Battery pads | Built-in PDB on wing boards |
- Servo rail
- Signal and BEC power for control surfaces
- Motor output
- ESC signal
- Receiver port
- CRSF, SBUS or PPM
- GPS / airspeed
- UART and I2C
- Battery pads
- Built-in PDB on wing boards
Wiring the Fixed-wing flight controllers and RC plane gyros
Check every control surface moves the right way in the stabilised mode before the first flight: tilt the plane and watch the ailerons and elevator counter the motion.
| Fixed-wing flight controllers and RC plane gyros pin | Connection | Note |
|---|---|---|
| Servos | S1 to S6 on the servo rail | Set rail voltage 5V or 6V |
| ESC | Motor output | BEC wire off if FC powers servos |
| Receiver | UART (CRSF) or SBUS pad | - |
| GPS | UART + 5V | Top of the plane |
- Servos
- Connection:
- S1 to S6 on the servo rail
- Note:
- Set rail voltage 5V or 6V
- ESC
- Connection:
- Motor output
- Note:
- BEC wire off if FC powers servos
- Receiver
- Connection:
- UART (CRSF) or SBUS pad
- Note:
- -
- GPS
- Connection:
- UART + 5V
- Note:
- Top of the plane
Example code
ArduPilot Plane users run the same steps in Mission Planner (Q_ settings for VTOL). For simple gyros, set gain and direction with the board's switches or app.
1. Flash iNav with the board's target
2. Mixer tab: Flying Wing preset, check elevon directions
3. Ports: Serial RX (CRSF) and GPS UARTs
4. Calibrate accelerometer with the wing level
5. Modes: ANGLE, NAV RTH, NAV POSHOLD (loiter), FAILSAFE = RTH
6. Outputs: servo endpoints and reversal
7. Launch mode for hand launch: NAV LAUNCH on a switch
8. Verify control surface directions in ANGLE before flyingSetup and tuning
mount the board flat with its arrow forward, or set the board orientation in the configurator.
use soft foam tape so motor vibration does not reach the gyro.
before every first flight, tilt and yaw the plane by hand and check each surface moves to oppose the motion.
use INAV or ArduPilot for GPS modes; simple gyros only need gain and mode switches set.
run accelerometer calibration on level ground and compass calibration away from metal.
set return to home, or circle and descend, when the radio link is lost.
What you need
Shop this list12 of 12 found in our store · ₹44,248
SpeedyBee F405 WING MINI Fixed Wing Flight Controller: the part this guide coversSpeedyBee F405 WING MINI Fixed Wing Flight Controller₹3,773
Holybro Kakute H743 Wing Flight Controller with Micro M10 GPS Module: another version this guide coversHolybro Kakute H743 Wing Flight Controller with Micro M10 GPS Module₹14,984
iFlight BLITZ Wing H743 Flight Controller: another version this guide coversiFlight BLITZ Wing H743 Flight Controller₹10,429
RadioLink Byme-DB Mini Fixed Wing Flight Controller: another version this guide coversRadioLink Byme-DB Mini Fixed Wing Flight Controller₹1,599
RadioLink Byme-A Flight Controller: another version this guide coversRadioLink Byme-A Flight Controller₹1,899
RadioLink Byme-D Flight Controller: another version this guide coversRadioLink Byme-D Flight Controller₹939
NX3 Pro 3D Flight Controller and Gyro Balancer for RC Planes: another version this guide coversNX3 Pro 3D Flight Controller and Gyro Balancer for RC Planes₹2,179
NX4 EVO Flight Controller: another version this guide coversNX4 EVO Flight Controller₹2,038
ReadyToSky FMS Reflex V2 RC Airplane Gyro Flight Control System: another version this guide coversReadyToSky FMS Reflex V2 RC Airplane Gyro Flight Control System₹3,059
BN-880 GPS and compass module: for GPS rescue and iNav navigationReadyToSky BN-880 GPS GLONASS Compass Module₹1,669Closest match, check the specs
ELRS 2.4G receiver (PWM/CRSF): the radio control linkHGLRC ELRS 2.4G Receiver₹1,581Closest match, check the specs
Servo tester: checks servos and control surfacesRC Servo Motor Tester (3-Channel)₹99Closest match, check the specs
Alternatives and when to choose them
- RC plane ESCs: motor control.
- F7 and H7 flight controllers: multirotor boards.
- Airspeed sensors: for ArduPilot Plane.
Common mistakes to avoid
- Flying without checking that each surface corrects the right way.
- Mounting the board backwards or on hard tape.
- Calibrating the compass next to the battery or motor.
- Leaving the failsafe set to hold the last stick positions.
Frequently asked questions
How do I check the gyro corrects in the right direction?
Roll the plane right by hand; the right aileron should go down to roll it back. Check every axis.
Which firmware is best for a fixed-wing plane?
INAV is easiest for GPS planes; ArduPilot adds more autopilot and mission features.
Do I need GPS on my plane?
Only for return to home, waypoints, position hold and speed or distance telemetry.
Why does the plane wobble in stabilised mode?
The gains are too high. Lower them a step at a time until the wobble stops.
Can I still fly the plane manually?
Yes. Most controllers have a manual or passthrough mode on a switch for take-off and emergencies.
Parts for this guide
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.


