Concept explainer · Beginner · 3 min read
FPV Antennas
RHCP vs LHCP, Omni vs Patch, SMA vs RP-SMA
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
FPV antennas for 5.8 GHz video use circular polarisation, either right-hand (RHCP) or left-hand (LHCP). The antenna on the drone and the one on your goggles must use the same polarisation or the signal drops sharply. Use omnidirectional antennas for flying around and a directional patch or helical for range, and never power a video transmitter without an antenna.
Key specs at a glance
- Polarisation
- RHCP is the common choice; LHCP reduces multipath for some pilots but must match
- Types
- Omni (pagoda, lollipop, dipole), patch, helical
- Gain
- Omni about 1.5 to 3 dBi; patch about 8 to 14 dBi
- Connector
- SMA or RP-SMA; match the VTX and goggles
- Frequency
- 5.8 GHz band for most analog and digital FPV
- Mounting
- Keep away from carbon fibre
Why polarisation matters
Circular polarised waves spin. A transmitter using RHCP and a receiver using LHCP lose a lot of signal, while two RHCP antennas work well. Circular polarisation also resists multipath reflections, which cause flicker. Pick one hand and use it on every drone and your goggles.
Antenna types
Combine an omni on the drone with an omni and a patch on the goggles for range.
| Type | Pattern | Use for |
|---|---|---|
| Pagoda / mushroom | Wide omni | Everyday flying, goggles |
| Lollipop / stubby | Small omni | Compact builds |
| Dipole | Omni with a null | Cheap spare |
| Patch | Directional, about 60 degrees | Longer range, clean video |
| Helical | Highly directional | Maximum range |
- Pagoda / mushroom
- Pattern:
- Wide omni
- Use for:
- Everyday flying, goggles
- Lollipop / stubby
- Pattern:
- Small omni
- Use for:
- Compact builds
- Dipole
- Pattern:
- Omni with a null
- Use for:
- Cheap spare
- Patch
- Pattern:
- Directional, about 60 degrees
- Use for:
- Longer range, clean video
- Helical
- Pattern:
- Highly directional
- Use for:
- Maximum range
Diversity setups
Goggles with two receivers often use one omni and one patch: the omni keeps video close by and the patch holds the link far away. Many pilots run an RHCP pagoda and a patch. Do not mix polarisations across the pair.
Fitting and safety
Match SMA vs RP-SMA with the VTX and goggles; see RF cables and pigtails. Mount the antenna so it stays clear of carbon plates and wires. Never power a video transmitter without an antenna attached, because the output stage can burn out. Keep the antenna from touching the receiver antenna, and replace damaged ones, since a worn coax shield reduces range. Check local power and frequency rules for video transmitters.
Try it: Link budget fspl calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Mixing RHCP and LHCP antennas.
- Powering the VTX with no antenna.
- Buying SMA when RP-SMA is needed.
- Mounting the antenna flat against carbon.
- Using a damaged antenna and wondering why range is short.
Frequently asked questions
RHCP or LHCP?
RHCP is the default. LHCP can reduce interference in groups, but you must switch all antennas.
Can I use a patch antenna on the drone?
No, patch antennas are directional and meant for the ground station.
What does dBi mean?
Antenna gain compared with an ideal radiator. Higher gain means a narrower beam.
How long can an antenna cable be?
Keep it short. Cable loses signal, especially at 5.8 GHz.
Do I need to replace stock antennas?
Not always, but better antennas improve range and reduce dropout.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.




