Shop by category
Shop all componentsTiming, filters & signals
Measure from the connector or feed point to the tip. Trim a little at a time while checking range or SWR, because nearby metal and cases shift the best length.
λ = c ÷ f = 299.8 ÷ f(MHz) metresQuarter-wave = k × λ ÷ 4Half-wave dipole = k × λ ÷ 25/8 wave = k × 0.625 × λAt 433 MHz the wavelength is 692.4 mm. A quarter-wave whip is 0.95 × 692.4 ÷ 4 = 164.4 mm of straight wire. At 868 MHz it is 82.0 mm, and at 2.4 GHz about 29.7 mm.
A simple antenna is a piece of wire cut to a fraction of the signal’s wavelength. A quarter-wave whip over a ground plane (or the second half of a dipole) is the cheapest and most reliable choice for modules such as 433 MHz receivers, LoRa SX1278 boards and ESP32 projects.
Wire cut to the exact free-space length is slightly too long because of end effects, so the shortening factor is about 0.95. Fine-tune with an SWR meter or a range test. Keep the wire straight and vertical, away from batteries and metal, and give it a ground plane if you can.
A quarter-wave whip for 433 MHz is about 16.4 cm of straight wire (17.3 cm in theory, shortened by about 5% for end effects). A 868 MHz whip is about 8.2 cm.
A quarter-wave whip works best over a ground plane such as a metal case or PCB ground. Without one, use a half-wave dipole or add radials.
About 3.1 cm, less a few percent for the velocity factor of the wire.
λ = c ÷ f = 299.8 ÷ f(MHz) metres; Quarter-wave = k × λ ÷ 4; Half-wave dipole = k × λ ÷ 2; 5/8 wave = k × 0.625 × λ. Here λ is wavelength, c is speed of light, 299,792,458 m/s and k is shortening factor (end effect), about 0.95.
At 433 MHz the wavelength is 692.4 mm. A quarter-wave whip is 0.95 × 692.4 ÷ 4 = 164.4 mm of straight wire. At 868 MHz it is 82.0 mm, and at 2.4 GHz about 29.7 mm.
Geekobot builds that use it include LoRa receiver with an OLED display, LoRa receiver with an alarm buzzer, LoRa farm gate open sensor and LoRa silkworm shed climate node. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators