Component guide · Intermediate · 3 min read
Panel Voltmeters, Ammeters and Current Shunts
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
A digital panel meter shows voltage and current on a small display built into a box or project. Voltmeters connect across the supply; ammeters measure the small voltage across a shunt resistor in series with the load. Low-range meters have an internal shunt, while 50 A or 100 A meters use an external shunt that drops 75 mV at full current. Most dual meters measure on the negative side.
Key specs at a glance
- Voltage range
- Typically 0 to 100 V DC
- Current range
- 10 A with internal shunt; 50 to 100 A with external shunt
- Shunt
- 75 mV at rated current (50 A / 75 mV shunt = 1.5 mΩ)
- Wiring
- 2-wire (powered from measured voltage) or 3-wire (separate supply)
- Display
- 0.28 inch dual LED or LCD
- Uses
- Bench supplies, solar, battery banks, chargers
Wiring a dual volt-amp meter
Most common dual meters have a thin 3-wire lead (red supply, black ground, yellow voltage sense) and two thick wires for current. Typically: 1. Red to the meter's supply (4.5 to 30 V on many), black to the supply negative. 2. Yellow to the positive voltage you want to measure. 3. The thick wires go in series with the negative line between supply and load (low-side shunt).
Wiring varies between models; follow the diagram for yours. With an external shunt, the shunt goes in the negative line and two thin wires go from its sense screws to the meter.
Choosing a shunt
Pick a shunt whose rating is above your maximum current, with the same mV rating as the meter (usually 75 mV). Its resistance is the mV rating divided by the current: 75 mV ÷ 100 A = 0.75 mΩ. Use the sense screws, not the big bolts, for the meter wires. The shunt heats up near full current, so mount it with air around it. See Ohm's law.
Panel meter or monitor IC?
For a display on a box, a panel meter is simplest. To log data or control something, use an INA219 or ACS712 with a microcontroller. For AC mains, use an energy meter module.
Try it: Ohm's law calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Putting the current wires in parallel with the load (a short).
- Mixing up thin sense wires and thick current wires.
- Using a shunt with a different mV rating from the meter.
- Exceeding the meter's supply voltage.
- Measuring on the positive side when the meter expects low-side.
Frequently asked questions
What does a 75 mV shunt mean?
It drops 75 mV when its rated current flows; the meter turns that voltage into a current reading.
Can a panel ammeter measure AC?
Not these DC meters. Use an AC meter or an energy meter module.
Why does my ammeter read zero?
The current probably does not pass through the shunt, often because the negative line bypasses it.
Can I use a panel meter on a 48 V battery?
Yes if its voltage range covers it and its supply input is within rating; some models need a separate supply.
Do I need the external shunt?
For meters rated 50 A or more, yes. 10 A meters usually have one built in.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.


