Pocket oscilloscope: build it, then measure PWM, a 555 and a function generator
Assemble a DSO138 kit and learn to read frequency, duty cycle and waveform shape on real signals.
Shop by category
Shop all componentsMost projects need a clean 5 V from a 12 V adapter or battery. This board teaches the core workshop skills on one piece of stripboard: planning tracks, cutting strips, soldering headers and connectors, crimping and heat-shrinking wires, and testing with a multimeter and a current-limited bench supply before anything expensive is connected. A glass fuse protects the input, an inductor and capacitors smooth the output, and a small panel meter shows the voltage.
Solder in a ventilated place and wash your hands after handling leaded solder.
Always put the hot iron back in its stand.
Never work on mains voltage with this board.
Tick anything you already have and the total updates.
Bootlace ferrules for wires going into screw terminals
Follow the colours: red is power, dark grey is ground, blue is a signal.
Needs a 12 V adapter (sold separately). Test first from a bench supply with the current limit at 200 mA.
There is a short: look for a solder bridge between strips or a missed track cut.
The buck module is not adjusted yet; turn its screw anticlockwise slowly while measuring.
The load needs more current than the fuse; check its rating, or a capacitor is fitted backwards.
60/40 rosin-core wire is easiest to learn with; use lead-free if you prefer, with a slightly hotter iron.
The fuse protects the board's wiring and your load from a fault, not just the adapter.
An LM2596 module gives up to about 2 A with good cooling; size the fuse and wires to match.
22 parts: Veroboard / Stripboard, LM2596 Adjustable Buck Converter Module, Glass Cartridge Fuse 5x20mm, Fuse Holder (Panel, PCB and HRC), Axial Colour-Ring Inductor, Electrolytic Capacitor by Value, Rocker Switch, Panel Digital Voltmeter / Ammeter, Berg Strip Header (2.54mm), JST XH 2.54 mm Male Connector, plus 12 more. Tools: Noel Soldering Iron, Solder Wire 60/40 Rosin Core, Soldering Flux and Paste, Desoldering Wick, Soldering Iron Stand, plus 6 more. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 3 hours. The build on this page has 7 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
Planning and cutting stripboard; Good solder joints and how to fix bad ones; Testing a power board safely with a current limit.
Solder in a ventilated place and wash your hands after handling leaded solder. Always put the hot iron back in its stand. Never work on mains voltage with this board.
Ideas that reuse this build: Oscilloscope first measurements. They are listed under Take it further on this page.
Assemble a DSO138 kit and learn to read frequency, duty cycle and waveform shape on real signals.
Learning project. Check every circuit and the datasheet of each part before you power it up.