Shop by category
Shop all componentsPower, batteries & solar
The regulator will overheat and shut down. Add a heatsink, drop the input voltage, or use a buck converter.
P = (Vin − Vout) × I load + Vin × I qT j = T ambient + P × θ JAEfficiency ≈ Vout ÷ VinA 7805 from 12 V at 500 mA: P = 7 × 0.5 + 12 × 0.005 = 3.56 W. Without a heatsink (50 °C/W) at 35 °C ambient the chip would reach 213 °C, so it needs a heatsink of about 25 °C/W total, or a buck converter.
A linear regulator makes a lower voltage by burning the difference as heat. Its efficiency is roughly Vout ÷ Vin, so dropping 12 V to 5 V wastes over half the power. That is fine at a few tens of milliamps, but at half an amp it gets very hot.
θJA (junction-to-ambient thermal resistance) tells you how many degrees the chip rises per watt. If the result is too hot, add a heatsink, pre-drop the voltage, or switch to a buck converter module that is 85–95% efficient.
Power lost is (Vin − Vout) × I. Dropping 12 V to 5 V at 0.5 A wastes 3.5 W, far too much for a TO-220 without a heatsink.
When the voltage drop times current is more than about 1 W. A buck converter wastes much less power as heat.
About Vout ÷ Vin. Going from 12 V to 5 V is only about 42 % efficient.
P = (Vin − Vout) × I load + Vin × I q; T j = T ambient + P × θ JA; Efficiency ≈ Vout ÷ Vin.
A 7805 from 12 V at 500 mA: P = 7 × 0.5 + 12 × 0.005 = 3.56 W. Without a heatsink (50 °C/W) at 35 °C ambient the chip would reach 213 °C, so it needs a heatsink of about 25 °C/W total, or a buck converter.
Geekobot builds that use it include Dashboard battery voltmeter for cars and bikes, Car cabin air-quality meter, Two-wheeler side-stand warning and Solder a fused 12 V to 5 V power board on stripboard. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators