Shop by category
Shop all componentsPower, batteries & solar
Remember a linear regulator after the capacitor needs about 2–3 V headroom above its output at the lowest point of the ripple.
V peak = V rms × √2 − diode dropsFull wave: C = I ÷ (2 × f × ΔV)Half wave: C = I ÷ (f × ΔV)12 Vac secondary, 1 A load, 50 Hz bridge, 1 V ripple: peak = 12 × 1.414 − 1.4 = 15.57 V, C = 1 ÷ (2 × 50 × 1) = 10,000 µF. Choose a 25 V capacitor.
After a rectifier the voltage is a series of bumps. A large capacitor charges at each peak and supplies the load between peaks, so the ripple falls as capacitance, frequency and permitted ripple rise.
Tolerances on electrolytic capacitors can be −20% or worse and their capacity drops with age, so round up. A bridge rectifier doubles the ripple frequency to 100 Hz on 50 Hz mains, which halves the capacitance needed compared with a half-wave rectifier.
C = I ÷ (2 × f × ΔV) for full-wave. For 1 A, 50 Hz and 1 V ripple that is 10,000 µF.
About 12 × √2 − 1.4 ≈ 15.6 V at the peaks, before ripple and regulation.
The capacitor is recharged only once per cycle instead of twice, so it must hold the load for longer.
V peak = V rms × √2 − diode drops; Full wave: C = I ÷ (2 × f × ΔV); Half wave: C = I ÷ (f × ΔV).
12 Vac secondary, 1 A load, 50 Hz bridge, 1 V ripple: peak = 12 × 1.414 − 1.4 = 15.57 V, C = 1 ÷ (2 × 50 × 1) = 10,000 µF. Choose a 25 V capacitor.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators