Shop by category
Shop all componentsOhm’s law & basics
This assumes the coils are far apart or shielded so that their magnetic fields do not couple. Coils wound close together or on one core also add or subtract their mutual inductance.
Series: L = L1 + L2 + L3 + …Parallel: 1/L = 1/L1 + 1/L2 + 1/L3 + …Two in parallel: L = (L1 × L2) ÷ (L1 + L2)10 µH, 22 µH and 47 µH. Series: 10 + 22 + 47 = 79 µH. Parallel: 1 ÷ (1/10 + 1/22 + 1/47) = 6.0 µH.
Inductors combine the same way resistors do: in series the values add, and in parallel the total is lower than the smallest one. Use series coils to reach a value you do not have in stock, and parallel coils to lower the value and share the current between two smaller chokes.
The simple formulas hold only when the magnetic fields of the coils do not link. On a PCB, keep unshielded inductors a few centimetres apart or turn them at right angles. Remember that the current rating of a series string is that of its weakest part, while parallel coils share current only roughly equally.
Yes, if their magnetic fields do not interact. In series the values add; in parallel the total is lower than the smallest coil.
Yes, but the string can carry only as much current as the weakest inductor, so check that rating.
L = (L1 × L2) ÷ (L1 + L2), assuming they are not magnetically coupled.
Series: L = L1 + L2 + L3 + …; Parallel: 1/L = 1/L1 + 1/L2 + 1/L3 + …; Two in parallel: L = (L1 × L2) ÷ (L1 + L2).
10 µH, 22 µH and 47 µH. Series: 10 + 22 + 47 = 79 µH. Parallel: 1 ÷ (1/10 + 1/22 + 1/47) = 6.0 µH.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators