Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
7 steps · about 125 minutes plus print time
Step 1 of 7 · about 15 min
Printers are shipped with the moving parts held still by screws, brackets, foam or cable ties. A lock left in place makes the motors grind on the first move and can bend a rod or strip a belt.
Step 2 of 7 · about 30 min
Step 3 of 7 · about 5 min
Step 4 of 7 · about 20 min
Step 5 of 7 · about 10 min
Step 6 of 7 · about 15 min
Step 7 of 7 · about 30 min
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
3D printing · filament printer setup
Many printers come part built: the upright frame, the screen, the spool holder or the filament sensor go on at home. Loose frame screws are a common cause of wobbly, shifted prints later.
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
The nozzle has to sit about one paper thickness above the bed at every corner. Too high and the plastic will not stick; too low and nothing comes out.
From the Creality CR-10 SE 3D Printer spec sheet
| Max Heatbed Temperature | ≤110 °C |
|---|
PLA is the easiest first filament: it prints at a low temperature and does not need an enclosure. Using the filament diameter your printer takes (almost always 1.75 mm) matters more than the brand.
From the Creality CR-10 SE 3D Printer spec sheet
| Extruder Type | Sprite Direct Drive |
|---|---|
| Filament Diameter | 1.75 mm |
| Supported Filaments | PLA, PETG, PET, TPU, PLA Wood, ABS, ASA, PA, PLA-CF |
| Hotend Configuration | Heat break: Copper + Titanium Alloys |
| Max Hotend Temperature | 300 °C |
| Standard Nozzle Diameter | 0.4 mm |
The slicer turns a 3D model into the layer-by-layer moves the printer follows. Starting from the maker's printer profile gives you tested speeds and temperatures.
From the Creality CR-10 SE 3D Printer spec sheet
| Connectivity | USB, Wi-Fi |
|---|
The test file that comes with the printer is already sliced with good settings, so a problem with it points to the setup, not to the slicer.
From the Creality CR-10 SE 3D Printer spec sheet
| Build Volume (L×W×H) | 220 × 220 × 265 mm |
|---|