Shop by category
Shop all componentsGrease from fingers is the most common reason a first layer stops sticking. A clean plate saves more failed prints than any setting.
Tip: textured and smooth plates have their own care notes from the maker; see PEI build plates.
Plastic stuck on the outside of the nozzle drops blobs onto the next print and can fool a nozzle-based levelling sensor.
Purge strands, supports and dust collect under the bed and around the toolhead, where they can jam a moving part or get pulled into a fan.
Many filaments take up moisture from the air, and damp filament strings, pops and prints weak. Desiccant only works until it is full.
Dust mixes with old lubricant into a paste that makes motion rough and noisy. Clean, lightly lubricated rods or rails run smoothly and last longer.
Belts stretch slowly. A loose belt causes ringing, wavy walls and layer shifts; one that is too tight wears the motor and idler bearings.
Vibration slowly loosens screws. A loose frame or gantry shows up as wobble, ringing and uneven layers.
The drive gears grind a little filament dust every print. Packed teeth slip, which looks like under-extrusion and clicking.
Dust and filament strands on the fans cut airflow. A weak hotend fan can cause heat creep and clogs; a weak part fan gives droopy overhangs.
Brass nozzles wear, and fast with abrasive filaments (carbon fibre, glow-in-the-dark, wood fill). A worn nozzle prints wider, rougher lines.
On Bowden printers and printers with a PTFE-lined hotend, a gap or a browned tube end makes filament catch and clog.
Cables to the bed and toolhead bend thousands of times. A cracked wire or a loose heater or thermistor plug can cause errors or heating problems.
Makers fix bugs and add calibration features in firmware updates.
Resin pigments settle, and a cured scrap left in the vat from a failed print can press through the film and damage the screen.
Cured resin left on the plate stops it sitting flat on the next print.
Resin left in the vat for days collects cured bits and dust. Filtering keeps it clean for the next print.
IPA full of dissolved resin no longer cleans parts, which leaves them sticky.
A dented, cloudy or scratched film makes prints fail, and a hole lets resin onto the screen.
Dust or dried resin on the screen blocks light and shows up as defects on every print.
The Z axis lifts the plate thousands of times. Dry or dirty lead screws and rails make it noisy and can cause layer lines.
Ticks are saved in this browser only, so they stay private to this device.
Filament (FDM) printers: handy parts and reading
Resin printers: handy parts and reading