Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
7 steps · about 125 minutes plus print time
Step 1 of 7 · about 15 min
Printers are shipped with the moving parts held still by screws, brackets, foam or cable ties. A lock left in place makes the motors grind on the first move and can bend a rod or strip a belt.
Step 2 of 7 · about 30 min
Step 3 of 7 · about 5 min
Step 4 of 7 · about 20 min
Step 5 of 7 · about 10 min
Step 6 of 7 · about 15 min
Step 7 of 7 · about 30 min
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
3D printing · filament printer setup
Many printers come part built: the upright frame, the screen, the spool holder or the filament sensor go on at home. Loose frame screws are a common cause of wobbly, shifted prints later.
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
From the Elegoo – OrangeStorm Giga 3D Printer spec sheet
| Output Voltage | 24V |
|---|
The nozzle has to sit a fraction of a millimetre above the bed everywhere. Auto levelling measures the bed at many points and corrects for small dips, but it still needs a clean plate and a correct Z offset.
From the Elegoo – OrangeStorm Giga 3D Printer spec sheet
| Max Heatbed Temperature | 100 °C |
|---|
PLA is the easiest first filament: it prints at a low temperature and does not need an enclosure. Using the filament diameter your printer takes (almost always 1.75 mm) matters more than the brand.
From the Elegoo – OrangeStorm Giga 3D Printer spec sheet
| Max No. of Nozzles | 4 |
|---|---|
| Supported Filaments | PLA, PETG, TPU |
| Max Hotend Temperature | 300 °C |
| Supported Nozzle Diameters | 0.6mm (Included), 0.4mm, 0.8mm, 1.0mm (Optional) |
The slicer turns a 3D model into the layer-by-layer moves the printer follows. Starting from the maker's printer profile gives you tested speeds and temperatures.
From the Elegoo – OrangeStorm Giga 3D Printer spec sheet
| Connectivity | Wi-Fi, USB, LAN |
|---|---|
| Supported File Formats | STL, OBJ |
The test file that comes with the printer is already sliced with good settings, so a problem with it points to the setup, not to the slicer.
From the Elegoo – OrangeStorm Giga 3D Printer spec sheet
| Build Platform Size | 820 x 820 mm (Comprising 4 independent 410 x 410 mm PEI plates) |
|---|---|
| Build Volume (L x W x H) | 800 x 800 x 1000 mm³ |