Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
7 steps · about 125 minutes plus print time
Step 1 of 7 · about 15 min
Printers are shipped with the moving parts held still by screws, brackets, foam or cable ties. A lock left in place makes the motors grind on the first move and can bend a rod or strip a belt.
Step 2 of 7 · about 30 min
Step 3 of 7 · about 5 min
Step 4 of 7 · about 20 min
Step 5 of 7 · about 10 min
Step 6 of 7 · about 15 min
Step 7 of 7 · about 30 min
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
3D printing · filament printer setup
Many printers come part built: the upright frame, the screen, the spool holder or the filament sensor go on at home. Loose frame screws are a common cause of wobbly, shifted prints later.
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
From the Prusa CORE One L 3D Printer spec sheet
| Rated Power | 630W |
|---|---|
| Output Voltage | 24V |
The nozzle has to sit a fraction of a millimetre above the bed everywhere. Auto levelling measures the bed at many points and corrects for small dips, but it still needs a clean plate and a correct Z offset.
From the Prusa CORE One L 3D Printer spec sheet
| Heatbed Temperature | Up to 120°C |
|---|
PLA is the easiest first filament: it prints at a low temperature and does not need an enclosure. Using the filament diameter your printer takes (almost always 1.75 mm) matters more than the brand.
From the Prusa CORE One L 3D Printer spec sheet
| Extruder Type | Nextruder Direct Drive |
|---|---|
| Filament Diameter | 1.75 mm |
| Filament Supports | PLA, PETG, Flex, PVA, PC, PP, CPE, PVB (ABS, ASA, HIPS, PA with optional filtration system) |
| Number of Nozzles | 1 |
| Hotend Temperature | Up to 290°C |
| Number of Extruders | 1 |
The slicer turns a 3D model into the layer-by-layer moves the printer follows. Starting from the maker's printer profile gives you tested speeds and temperatures.
From the Prusa CORE One L 3D Printer spec sheet
| Connectivity | Ethernet, USB Drive, LAN, Prusa Connect, Mobile App, NFC |
|---|
The test file that comes with the printer is already sliced with good settings, so a problem with it points to the setup, not to the slicer.
From the Prusa CORE One L 3D Printer spec sheet
| Platform Size | 300 × 300 mm |
|---|---|
| Print Size (L x W x H) | 300 x 300 x 330 mm |