Shop by category
Shop all componentsTiming, filters & signals
In a series circuit the impedance is lowest at resonance (equal to R) and the current is highest.
Series: Z = R + j(ωL − 1/ωC)|Z| = √(R² + (XL − XC)²)Parallel: 1/Z = 1/R + j(ωC − 1/ωL)f0 = 1 ÷ (2π√(LC))Q series = (1/R)√(L/C), Q parallel = R√(C/L)Bandwidth = f0 ÷ QSeries R = 100 Ω, L = 10 mH, C = 1 µF at 1 kHz: XL = 62.8 Ω, XC = 159.2 Ω, so |Z| = √(100² + 96.3²) = 138.8 Ω with a phase of −43.9° (capacitive). Resonance is at 1.59 kHz with Q = 1.
An RLC circuit combines the resistance, the inductor’s opposition to changing current and the capacitor’s opposition to changing voltage. The inductor and capacitor cancel each other at the resonant frequency, leaving only the resistance, which is why radios and filters tune with them.
A high Q factor means a narrow, sharp resonance with little loss, as in a radio tuner or crystal-like filter. A low Q gives a broad, damped response. Coil resistance lowers the Q, so add it to R when you model a real circuit.
It is f = 1 ÷ (2π√(LC)). At this frequency the inductive and capacitive reactances are equal and cancel, so a series circuit shows only its resistance.
Q tells you how sharp the resonance is. A higher Q gives a narrower bandwidth (f0 ÷ Q) and less loss; a low Q is broad and heavily damped.
f0 ÷ Q. A high Q gives a narrow, sharp resonance.
Series: Z = R + j(ωL − 1/ωC); |Z| = √(R² + (XL − XC)²); Parallel: 1/Z = 1/R + j(ωC − 1/ωL); f0 = 1 ÷ (2π√(LC)); Q series = (1/R)√(L/C), Q parallel = R√(C/L); Bandwidth = f0 ÷ Q. Here ω is 2π × frequency, XL is inductive reactance, ωL, XC is capacitive reactance, 1/ωC and Q is quality factor.
Series R = 100 Ω, L = 10 mH, C = 1 µF at 1 kHz: XL = 62.8 Ω, XC = 159.2 Ω, so |Z| = √(100² + 96.3²) = 138.8 Ω with a phase of −43.9° (capacitive). Resonance is at 1.59 kHz with Q = 1.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators