Shop by category
Shop all componentsMotors & mechanics
Measure with a multimeter between the trimmer’s wiper (the metal screw) and GND, with the motor supply on. Turn the trimmer in tiny steps.
A4988: Vref = I × 8 × RsDRV8825: Vref = I × 5 × RsTMC2209: Vref = I rms × √2 × (Rs + 0.02) × 2.5 ÷ 0.325A 1.5 A motor at 80% = 1.2 A. A4988 with 0.1 Ω sense resistors: Vref = 1.2 × 8 × 0.1 = 0.96 V. A DRV8825 needs 0.60 V, and a TMC2209 with 0.11 Ω resistors needs 1.70 V.
Stepper drivers limit the motor current with a reference voltage set by a small trimmer potentiometer. Too low and the motor loses steps; too high and the motor and driver overheat.
Aim for about 70–90% of the motor’s rated current to leave some margin, and add a heatsink and airflow to the driver. Different boards use different sense resistors, so the formula changes between clones. Always measure Vref with the motor supply powered but the motor idle.
Between the metal wiper of the trimmer potentiometer and GND, with a multimeter, while the board has logic and motor power.
Its current-sense amplifier has a different gain, so the factor is 5 instead of 8.
The motor and driver run hot and may skip steps or overheat. Start at about 70 % of rated current.
A 1.5 A motor at 80% = 1.2 A. A4988 with 0.1 Ω sense resistors: Vref = 1.2 × 8 × 0.1 = 0.96 V. A DRV8825 needs 0.60 V, and a TMC2209 with 0.11 Ω resistors needs 1.70 V.
Geekobot builds that use it include Stepper photo turntable, Stepper-motor dial thermometer, Pico stepper dial set by a knob (MicroPython) and Stepper soil moisture dial. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators