Shop by category
Shop all componentsMotors & mechanics
About 4 kHz is the practical limit for simple Arduino libraries such as AccelStepper on an Uno. Use a faster board or a driver that generates its own steps.
Motor torque falls quickly with speed. Most NEMA 17 motors lose much of their torque above 600–1000 RPM unless the supply is 24 V or more.
Steps per rev = (360° ÷ step angle) × microstepsStep rate = RPM × steps per rev ÷ 601.8° motor at 1/16 microstepping: 3200 steps per revolution. For 300 RPM you need 300 × 3200 ÷ 60 = 16,000 steps per second (16 kHz).
Each pulse on a stepper driver’s STEP pin moves the motor by one step. Faster rotation needs a higher pulse rate, and microstepping multiplies the number of pulses needed per revolution.
High microstepping is smoother and quieter, but it needs a faster controller. If your controller cannot keep up, lower the microstepping, or use a board with hardware step generation.
Step rate = RPM × steps per rev ÷ 60. 300 RPM with 3200 steps per rev needs 16,000 steps/s.
Torque falls as speed rises. Use acceleration, a higher driver voltage or fewer microsteps.
Often 600 to 1000 RPM at 24 V with light loads, less at 12 V.
Steps per rev = (360° ÷ step angle) × microsteps; Step rate = RPM × steps per rev ÷ 60.
1.8° motor at 1/16 microstepping: 3200 steps per revolution. For 300 RPM you need 300 × 3200 ÷ 60 = 16,000 steps per second (16 kHz).
Geekobot builds that use it include Stepper photo turntable, Stepper-motor dial thermometer, Pico stepper dial set by a knob (MicroPython) and Stepper soil moisture dial. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators